CAMO MARKSMAN Edge, Deck Screw Guide for Fastener Free, No Gap, Deck Surface Installation (0345020)

Used this tool along with camo pro x1(?) and it's amazing. The tiniest of holes on the sides of your deck boards. This tool is great for putting down the deck boards up against the house wall or for wider steps that the camo pro x1 isn't wide enough to use. It's amazing the look with no visible screw heads or holes on the top of your deck boards.

I sent it back and got the double edge shooter. That made my deck job much quicker. Great tool!

This tool worked exactly as advertised. Consistency with the angle and when applying pressure is very important to achieve desired penetration of the screws. I did have to follow up a number of times with the bit to finish driving the screws in flush but that was very easy to do. Also make sure to not push down on the handle before you start drilling. Overall very pleased.

A little hard to use at first and you have to practice on scrap lumber to get the hang of it. Then take your time lining it up. Then when using , it drives the screw to the correct depth.works on different length screws..If you are side screwing your deck boards this will work but, it is time consuming. One con is you have to look down level with the deck board to make sure that it’s positioned correctly. A see thru window would be an improvement.

There is an error in their ads and literature. They recommend using their stainless steel CAMO screws for outdoor applications with the CAMO Edge driver but the problem is that screws are not magnetic and the only way to use this tool is to use magnetic screws. The screw falls out of the tool due to gravity because there is nothing to keep the screw engaged with the driver as you try to drive the screw into a plank. I will also add that their customer service was very poor and the person I spoke with did not understand the roll magnetism plays in using their tool.

I'm a little torn on this product. I used it for a 550sqft deck. Despite claims that you can remove boards individually, its not possible if you butt the boards against each other like this tool is made to do. Also, if you butt the boards, one of the screw holes will definitely be visible because you can't go into the side of the board like the tool is designed to do. With all that being said, the tool held up to 1750 screws and I only went through one bit. You have to get used to the angle, because if it goes in at the wrong angle you'll need to drive the screw in with the bit by itself (I kept an extra bit handy so i didn't have to disassemble the jig every time). One very nice thing about the tool is that it holds the screws in there really well, so you're not fussing with holding the screw with your fingers and going in at the wrong angle.

This works very well. I installed a 297 sq ft deck running on a diagonal without issue. Another review made me hesitant to purchase this, but I bought two, and was able to secure all the decking in a day and a half with one helper. I wanted to use this fastener in particular as I was butting all the boards tight without any spacing.

At local Menards it cost $19.95 and overall it's useless tool compare to Camo Marksman which is a great tool.

idéal pour le vissage en angle des pièces de 1-1/2'' d'épaisseur (le 2x4 traditionnel).

This is far better than screwing boards in from the top. However... Pay attention to how the tool is placed before you set a screw, as removing one that is sticking out, is difficult.

Va bien. Met les vis dans le côté de la planche donc aucune vis visible pour un patio unis. Très satisfait du résultat.