SPECSTAR Under Hoist Support Stand 3/4 Ton Jack Stand, 1650Lbs Capacity, Adjustable 52-76 Inch Height, 12 Inch Diameter Base for Vehicle Lifting & Support

I just got my 10,000 lb 2 post lift installed and before I started pulling on and tugging. I put 1 support by the hitch and the other at the very front. These under-hoist supports kept the 2017 Dodge 1/2 ton crew cab 4x4 solid while I was lowering the rear end safely using the screw down option. I was wanting these for the cheap insurance as in the caption but they did a great job . The assembly was minimal shipped fast although heavy well packed right to my front door. I did a lot of research and this was definitely the best bang for the buck. Most definitely would buy again.

I needed a beam to support a rack that I had made to hang all my clothes. I was able to move the wooden racks that I had made further apart and use this beam in the center to support the weight of the clothes. Highly recommended.

I selected the “used” option when I ordered. The box was beat up but the product was all there. No instructions on how to put it together, but with some common sense we figured it out. Make sure you grease the bearing, and the threaded pole does have a rotation. Note small weld points on the thread, those are to prevent you from extending it out too far. Great value!

base was not welded perpendicular to the post so it leans a little. I am confident it will hold a transmission.

Got this to lift the broken ends of our dock for repair. It pushed up hundreds of pounds pretty handily. We used it in the water. Be sure to grease those bearings if doing the same.

great helper.

I use this in conjunction with my vehicle lift when needed. Sturdy and does the job.

Love it. Plan on buying another