Firecore FS18626 3-in Wide SDS Max Scaling Chisel, Compatible with SDS Max Hammers (3" X 12")

Fit the drill and worked perfectly, tears out tile and underlayment well.

Appears to be good quality and reasonably priced. I purchased this for tile removal and after breaking up 1000sf of tile it is holding up well.

Seems to be a good product

Works nicely in ENEACRO SDS-Max Demolition Jack Hammer. Tore out a chimney that was no longer being used. Bought it for the length and also needed a wider chisel to crack block, not to punch holes.

sturdy, good quality, make the job more easier

Product was as ordered and worked great for removing floor tile and thin set mortar.

WORK GREAT AT LOW PRICE

Like the size and finish. Unfortunately, when inserted into my SDS Max tool, the curve of the chisel is off 180degrees (chisel curves down relative to the tool). So to use as intended the entire tool needs to used upside down (which defeats many of the tool’s ergonomic features). I’m hoping the Vendor can replace these with chisels with the correct bend…I reached out but no reply yet. Update: vendor responded to my concern and pointed out that it is possible to easily rotate the machine’s chuck (a fact not mentioned anywhere in the machine’s manual). This made it possible to use the chisel in my machine as intended. Knowledgeable and prompt customer service…a rare pleasure these days.

.

These tiles were not coming off as easily as most do. The tiles were back buttered and laid in a thick mortar bed 40 years ago. Rock-hard mortar was well bonded to the plywood subfloor. Usually, I use my smaller SDS Plus hammer drill, but it wasn’t up to this small but tough job. With my bigger hammer, this 3-inch SDS Max bit went through 45 square feet of them in about 15 minutes. The bit has a nice edge that cuts through tile on impact. At the end of this little job, the bit was barely scratched, and the bit’s edge was intact.

Fatura alamam mümkünmü

Should last a long time ,we will see after a few thousand tiles are gone

Good quality tool. So far it's holding an edge fairly good.