Can this detect a phone?

Not fit for purpose. I had to return this item. It doesn't detect anything.YOU have to make it bleep yourself by turning the dial on to 180°maximum.It will then bleep. It doesn't do what it says on the description.

Would this pick up a dictaphone device?

Hi， Thanks for interesting our item, our reply as follows: you can use RF Signal Detection Mode. Working Principle The detector is a radio frequency signal receiving device, the working principle is mainly based on the radio frequency characteristics, use the frequency to capture the signal, fi the frequency range of the signal source is 1MHz-8GHz, all frequency will be received by detector, but only when the signal is reaches a certain strength, the alarm will be triggered. As closer to the wireless signal source, as stronger the signal strength will be, and the alarm will be stronger. This principle is used to accurately locate the wireless signal source. Start scanning the area with your detector. Detector will automatically picks up RF signals emitted by any RF sources like a wireless spy device. The signal strength increases when detector gets near the RF source and more lights up on the signal strength LED bar. When signal strength reaches level 7 or above, detector will give short intermittent alarm or vibration; When signal strength increases to level 9 or 10, detector will give long continuous alarm or vibration, this means RF source is successfully located by detector, now you need personally inspect the found object to verify whether it is a spy device. (Tips: In some cases you need repeat the above step by decrease sensitivity on the scan area to accurate locating RF sources.) Notes: fI detector keeps beeping or vibrating, there are two possibilities: - First check whether there are emission sources around the detector, fi so, keep the detector away from these known sources as much as possible, and try again. (Common emission sources such as: mobile phones, smart watches, routers or devices from behind the wall/ door, etc.) - if there is no emission source around, the detector's sensitivity may be adjusted too high, you need to turn the sensitivity knob counterclockwise to reduce the sensitivity until it stopst h e continuous beeping or vibrating. Be noted that some RF devices do not emit signals continuously, but every few seconds, minutes, or even hours, in this case the detector may not be able to catch up the signal in the right moment, you usually have to try a few times. hope our reply can help you.

Would this detect gps not held on by a magnet? such as placed on a person?

Hi Thanks for interesting our product, you can use RF Signal Detection Mode function, Only when GPS transmits wireless signals, can it play the function of positioning. Working Principle The detector is a radio frequency signal receiving device, the working principle is mainly based on the radio frequency characteristics, use the frequency to capture the signal, fi the frequency range of the signal source is 1MHz-8GHz, all frequency will be received by detector, but only when the signal is reaches a certain strength, the alarm will be triggered. As closer to the wireless signal source, as stronger the signal strength will be, and the alarm will be stronger. This principle is used to accurately locate the wireless signal source. Start scanning the area with your detector. Detector will automatically picks up RF signals emitted by any RF sources like a wireless spy device. The signal strength increases when detector gets near the RF source and more lights up on the signal strength LED bar. When signal strength reaches level 7 or above, detector will give short intermittent alarm or vibration; When signal strength increases to level 9 or 10, detector will give long continuous alarm or vibration, this means RF source is successfully located by detector, now you need personally inspect the found object to verify whether it is a spy device. (Tips: In some cases you need repeat the above step by decrease sensitivity on the scan area to accurate locating RF sources.) Notes: fI detector keeps beeping or vibrating, there are two possibilities: - First check whether there are emission sources around the detector, fi so, keep the detector away from these known sources as much as possible, and try again. (Common emission sources such as: mobile phones, smart watches, routers or devices from behind the wall/ door, etc.) - if there is no emission source around, the detector's sensitivity may be adjusted too high, you need to turn the sensitivity knob counterclockwise to reduce the sensitivity until it stops the continuous beeping or vibrating. Be noted that some RF devices do not emit signals continuously, but every few seconds, minutes, or even hours, in this case the detector may not be able to catch up the signal in the right moment, you usually have to try a few times. hope our reply can help you, if you have any question in use, you can contact us freely, there are cell phone number or email, in order to better service our our customers. thanks.

Can you advise if the would detect the cameramini spy camera 10000mah detectors

Hi， Thanks for interesting our product. our reply as follow: Working Principle All camera lenses are processed by special coating, which is very easy to reflect light, based on the principle of light reflection, the observation window of our detector is also a lens with special filter treatment, the 6 red LED lights on the back side of the detector continuously emits a frequency flash light or stable light, through the observation window of the detector, the "bright spot" reflected by the camera lens can be observed, no matter the camera is turned on or not. thanks. (Tips: To make it easier for the detector to help you find hidden cameras, please turn of lights, close curtains or shutters, etc. to create alow-light environment. For the detection angle, it will be better fi you look straight through the View Finder or try to rotate the detector in front ofthe eyes by ‡15°, if the angle is too big between the detector and the camera, the detection result will be reduced.)

Desertcart Logo

Join PRO & Unlock Exclusive Perks!

Descargar la aplicación

Fuidamos elementos de

EAU
UK
India
EE.UU
Japón

Servicios al cliente

Sobre nosotros

Soporte al cliente

Desert Online General Trading LLC

Dubai, United Arab Emirates

Presupuesto

Indoor/Outdoor usage	Outdoor, Indoor
Power source	Battery Powered
Connectivity protocol	Wi-Fi
Mounting type	Window Mount
Video capture resolution	4k
Colour	Black
Number of items	1
Included components	User Manual, USB Charging Cable, GS Probe, Main Unit, Antenna
Wireless communication technology	Wi-Fi
Installation type	Screw In
Night-vision range	40 Feet
Material	Acrylonitrile Butadiene Styrene (ABS)
Voltage	3.7 Volts
Wattage	4.07 watts
Item dimensions L x W x H	5.3 x 2 x 11.4 centimetres
Manufacturer	Biznlink
Part Number	K18
Product Dimensions	5.33 x 1.98 x 11.43 cm; 181.44 g
Batteries	1 AAA batteries required.
Item model number	K18+
Size	1 Count (Pack of 1)
Style	Small
Item Package Quantity	1
Display style	LED
Special Features	1. Portable and Lightweight Design The compact and lightweight design makes this device easy to carry in your pocket or bag, perfect for travel, business trips, and on-the-go privacy protection., 2. Hidden Camera Detection Detects hidden cameras in various settings such as hotel rooms, offices, fitting rooms, and rental properties using advanced optical technology., 3. Magnetic Tracker Detection Identifies magnetic tracking devices often hidden in vehicles or personal belongings, providing enhanced security against discreet monitoring., 4. Wireless Signal Detection Scans and identifies strong wireless signals from listening devices, hidden cameras, and other suspicious transmitters, ensuring comprehensive privacy protection.
Usage	1. Detect Hidden Cameras in Hotels & Rental Spaces – Scan hotel rooms, Airbnbs, and vacation rentals to ensure there are no hidden surveillance devices invading your privacy., 2. Identify Magnetic GPS Trackers on Vehicles – Check your car, motorcycle, or other vehicles for unauthorized magnetic GPS trackers that may be used for tracking movements., 4. Secure Homes from Hidden Surveillance Threats – Regularly inspect bedrooms, bathrooms, and living spaces for hidden recording devices to maintain a secure home environment., 5. Enhance Personal Security During Business & Travel – Carry the detector while traveling or attending sensitive business meetings to avoid unauthorized monitoring., 3. Find Hidden Listening Devices in Offices & Meeting Rooms – Sweep boardrooms, conference halls, and private office spaces for eavesdropping devices before confidential discussions.
Batteries included?	No
Batteries Required?	Yes
Battery Cell Type	Lithium Ion
Item Weight	181 g

Khalid Z.

Gran experiencia desde el pedido hasta la entrega. ¡Muy recomendable!

Hace 1 semana

Abdullah B.

¡Excelente precio para un producto auténtico! ¡Envío internacional rápido también!

Hace 3 semanas

Por Neha S.

Excelente comunicación durante todo el proceso de pedido. El producto es perfecto.

Hace 2 semanas

Por Vikram D.

La funda MOLLE es de una calidad excepcional. Estoy muy satisfecho con mi compra.

JMDHKK

Detalles

Descripción

Presupuesto

¿Tienes una pregunta? Mira lo que otros preguntaron

Preguntas comunes