Goldblatt G05141 Drywall Circle Cutter

A must have for drywallers. Works as it should and is built well.

This cutter was built much sturdier than ones of previously purchased.

Well built. Accurate. It's actually a good "scoring" device. The blade isn't big enough to cut through the sheetrock. Exactly what I needed, I couldn't use a traditional hole cutter, because that would require drilling a hole through the center.

Goldblatt has been great so far and this circle cutter works great. Mostly needed to cut out puck lights that everyone is starting to use more often now. I've used these before they last a long time, very durable.

Mw gusta el peso de este producto al ser mas pesado da maa firmesa sobre el drywall al momento de cortar

worked well

It is metal and has a sharp cutting wheel. I had to press hard to cut through the drywall paper and into the drywall. I was cutting 5/8” thick drywall, so extra thick and difficult to cut through. This tool does not have great ergonomics - and needed bigger, better ways to grip the tool to apply enough pressure to cut the drywall. In the end, the tool worked and did enable me to cut 8” round holes through 5/8” thick drywall. Not easy, but doable in a pinch.

I bought this to avoid using a hole saw for a recessed light. It looks and feels like a good solid tool, but it just rolled across the paint on the knock-down ceiling.

Had to install ceiling lights with an unusual diameter size. Could not access drywall from other side of ceiling so I only was able to start the cut from the Lighting side. It made a perfect starter cut. I then used a utility knife to cut right trough the drywall. Worked perfectly. Of course if you have the opportunity to access both sides of the drywall you're supposed to make a cut on either side and the drywall just pops out.

De muy buena caludad

justo lo que esperaba, es un producto de muy buena calidad

Great little product but not without issues. Pros: precisely marks and starts your circular cut outs. Easy to finish with an X-Acto blade. Cons: does not go all the way through the board. (A bigger wheel would solve this... Cuts up your fingers if you are not careful where you place them. My thumb ran into the roller cutter a few times.

Bonzinho, mas a lâmina poderia se maior pra cortar mais profundamente