ELEGOO 8K Water Washable Resin, Higher Precision 3D Printer Resin, 405nm Rapid UV Curing Photopolymer Resin, 3D Resin for LCD/MSLA/DLP 3D Printer Printing, 8K Space Grey 1000G

Don't let the picture deceive you. I wanted to post it to warn people that it might happen, but also wanted to sing the praises of the product. This is the second bottle of the Clear Red resin I have purchased, and it is an excellent resin. It has a slightly stronger odor than the Solid Gray resin of the same type, but the prints come out beautifully. My second bottle arrived damaged. However, thanks to the packaging it arrived in, the liquid was all contained inside an air-tight bag, and funneling it into my old bottle was a piece of cake. The bottle could possibly use a bit of reinforcement on the lid to prevent this in the future, as it seems that section of the lid may be a weak point in the construction. Included is a picture of some minis that I've printed to show off the clarity of the resin. These were printed on the Elegoo Mars 2 Pro. (Camera's not stupendous, though) TLDR - Product is excellent, moderate odor, good clarity after printing. Bottle has a glaring weak-point, but packaging around it is air-tight baggy, so no problem.

Overall I would have to say I liked this product. It shows wonderful details in the finished product, easily washes off under water, and has a is low odor when printing. The viscosity is great and I had no problems on models I vented and supported properly. The only downside I have found is that it is a very brittle product once cured. Small pieces can easily snap off. When used for printing miniatures (my primary use) the smaller details are often the most crucial.

excellent product

These resins have beautiful color to them and look good solid or hollow, though the solid models do look better. I've printed in the smokey black, green, and blue colors and I'm very happy with all of them! The water-washable aspect has completely changed my printing habits. Using IPA in the past was a major headache and annoyance. With the water-washable, I can simply put about a gallon of hot water in a tub and use a toothbrush to clean up the miniatures. Rinse them off in another small tub of cool water, then place in front of a fan to dry off before curing. The used water can then be left outside in the sun for a few hours to cure the washed-off resin. Strain the water and toss the cured resin. Easy peasy and no spending $$$ on IPA and dealing with fumes, storage, etc.

I needed this for a lighted red base in a diorama. Completely satisfied with the color saturation but the disk is 1cm thick. Carries light perfectly and great color. The supports pictured above are less than 2mm and are completely washed out. Water washable is great but needs slightly longer layer time than my others. However, I found times for all elegoo water washables to be consistent. Except for black. That required a little more exposure

Low odor and high resolution. Easy to work with and clean up is cake. Highly recommend.

Me gusta bastante, se limpia fácil, no tiene tanto olor comparado con otros colores y marcas. Hasta el momento se me hace muy fácil de imprimir, y las impresiones quedan de muy buena calidad, se me caen desde un metro de altura y no se rompen fácilmente. La única desventaja es que secar el agua de la resina es muchisimo más lenta que el alcohol, aunque lo pongamos al sol. Pero eso pasa con todas las resina lavable en agua (no tiren el agua por el lavabo)

Great

Funcion abien con mi impresora

No failed prints, No after prints problems and most of all the printed parts fits and no shrinkage. I'm ordering 2 more of 1KG of this resin as of writing this review. I never imagined I will be happy printing in Black colour and the after print is in Matte not glossy. Perfect!