Entregar a Mexico
IPara la mejor experiencia Obtener la aplicación
SN65HVD230 CAN Bus Module Communication Module CAN Bus transceiver
Descripción
🚀 Elevate Your Communication Game!
- SAFETY FIRST - Equipped with thermal protection and open circuit failure safeguards for reliable operation.
- UNMATCHED SPEED - Experience lightning-fast data transfer rates of up to 1Mb/s, ensuring seamless communication.
- ENERGY EFFICIENT - Enjoy low current consumption with a standby mode of just 370μA, keeping your systems running smoothly.
- ROBUST CONNECTIVITY - Connect up to 120 nodes effortlessly, making it perfect for expansive network setups.
- INTERFERENCE IMMUNITY - Designed to thrive in high-interference environments with advanced EMI and RFI protection.
The SN65HVD230 CAN Bus Module is a high-performance communication transceiver designed for robust data transfer in challenging environments. Fully compliant with ISO11898 standards, it supports up to 120 nodes, operates at a signal transfer rate of 1Mb/s, and features low power consumption and advanced interference protection.
Reseñas
B**.
Worked fine, no issues!
Worked fine. FYI surface-mount termination resistor is soldered in place (easy to remove if necessary).
A**C
Received 2/2 duds!
Bought two of these because I thought the form factor would be convenient over Waveshare's offering. Both were duds. While the Tx and Rx lines seemed to work (sending would result in a confirmation on the rx side), the CAN H and L sides were stuck at 1.65V while transmitting, and nothing came out of Rx while receiving.
C**.
Good board with one major drawback
I really wish there was an option to get these WITHOUT the 120ohm resistor on-board. The description states "allowing 120 nodes" but with that resistor on the board, it makes it so that no more than two can be used on any CAN bus. Please update the product description to the current configuration.Desoldering these by hand is a pain.
A**R
... 120 ohm resistor across the bus however it is easy to remove
The other review is correct there is a 120 ohm resistor across the bus however it is easy to remove. Will run at 3.3V or 5V even though 3.3 is recommended. (data sheet allows up to 5.5V MAX) Using with stm32f4 works fine.
J**F
Works great with a Teensy 3.5.
Works great with a Teensy 3.5. Removed terminating resistor with a soldering iron.
Preguntas comunes
Trustpilot
Hace 4 días
Hace 2 semanas
