Dayton Audio CE Series CE65W-8 2-1/2" Shielded Extended Range Driver 8 Ohms

Bought this to replace the subpar Yaesu SP10 speaker. Sounds a million times better. Seller should tape box shut so speaker stays in box during shipping. Thankfully just minor bend on mounting hole. Pilar’s easily fixed

My speaker blew on my Aomais speaker. Bought these speakers to replace the old ones. They are a little taller then the ones came with the speaker and a little smaller for the hole but I positioned them the best I can and they worked just fine. Sound better then the old ones also. I don’t intend on taking the speaker near the water so I think it will be fine.

I replaced a failed speaker in my Logitech THX PC speaker set. It was not a perfect fit but I did get it to work and it sounds great. Worth the money to save a great 5.1 surround sound system. I would definitely recommend this driver.

Suena muy bien y se adapta a mi barra de sonido marca vizio

It will replace the speaker, but it will not fit the same or allow your speaker to be water resistant anymore. The screw holes are just a hair off so you'll have to screw in at an angle. The seal is a thin piece of foam that does not cover the contact point or offer waterproof ability. Sound quality isn't as deep as stock.

I wasn't a huge Dayton audio fan. I thought they were overpriced and I still hate the fact that parts express doesn't do free shipping and prime. Don't normally do business unless they have prime. I ordered these anyway. Ok they are a top notch seller. Everything was packaged so perfect, documentation for everything. Had an issue with something and returned no problem. These speakers are rated at 7 watts. If you feed then clean power they can handle easily 20-50 watts. With the extended range you can pair with a woofer and that's all you need. They have an absolutely crystal clear sound and separation. Horns sound encredible. I'm going to in the future do an array setup which I can imagine will sound so good. These are worth every penny. I would say they rival some of the best speakers at far higher price.

I saw this speaker recommended on a Facebook page to replace the speaker for the SP-10. It took about 15 minutes to replace the crappy speaker that comes within the SP-10 and didn't even require drilling. Tabs are clearly marked for positive and negative. Sounds great with a deeper clearer sound being emitted. Packaging that it came in was very odd. sort of a large envelope with the speaker bouncing around inside but it seems tough enough to withstand that sort of punishment. KC5LL

First day sound good. Next day sound weird, open it again and the magnet of one of them was tear apart. Is made in china anyway + cheap. Amazon shouldn’t sell products like that. Is not good for them. Wouldn’t buy it again 😡

FT-991Aの海外ファンサイトでAmazonで購入したスピーカーと取り替えているのを見て即、Amazonで購入して取り替えました。 SP-10のスピーカーは昔のトランジスタラジオのスピーカーのような薄いもので音的には本体と比べて良いとは言い難いものでした。 半信半疑で取り替えたところ、低音が出て音声が締まり、了解度が上がり聞きやすくなり長時間でもストレスなく聞けそうです。 これでデザインだけの外部スピーカーから本体より良い音質という機能も備えたSP-10になり大満足です。

I ordered one of these (make that two since I have another TL to build) to finish up a some transmission line enclosures that I've printed off. Especially for how cheap these are compared to the more bougie options that are available, they do a shockingly decent job as a mid-bass driver given the tiny size. There's really not that much surface area available to generate all that much pressure for any form of gut-punching bass, but give these little guys a tuned port cabinet or a transmission line, then be strategic with your room placement and it's more than possible to have one of these rattle your noggin just the absolute tiniest little bit if you drive them hard enough. In the transmission line enclosures I'm using, these drivers can just about squeeze an audible 40Hz, but they become extremely noticeable once you pass the 100Hz region... That's where these drivers (enclosure permitting) can just about tap you in the chest and occasionally rattle the ol' nut when set loud enough. I'd generally advise though, as Dayton advertises, using these more as am all-round mid-bass to treble range driver given they don't really have a whole lot of excursion (movement of the cone) to make up for the lack of driver size. Again - you *can* achieve the tiniest amount of sub-bass with these drivers like I have managed to with a tuned enclosure and placing the completed speaker where the bass resonates, such as an enclosed shelf or under a desk... But it's really not worth trying to push every single decibel you can from a driver running outside the sensitivity range it's optimised for. You're just asking to release the magic smoke doing that!! The drivers themselves aside... I also really love the fact Dayton provides the characteristics for all of their drivers on their website. It makes obtaining the numbers you need to plug into the calculations for cabinet, porting or transmission line length much easier to find... Definitely beats renting a hard-to-find testing setup complete with anechoic chamber and measuring the characteristics manually!!

Mit einem Hochpasskondensator (220uF-330uF) kann man dieses winzige Chassis in einem geschlossenen! Gehäuse (2,3Liter) trotzdem hervorragend verwenden. Optimal linear bis 3kHz geht es auch mit kleinen Abstrichen als Fullrange durch. Schmalbandige Senke bei 8kHz (7dB). Sperrkreis: 0.68mH - 10uF - 12 Ohm ist zwingend erforderlich. (w.g. Bafflestep) 90Hz-16kHz +-2dB sind aber für ein 7€ Chassis herausragend.

The only problem, was connect the woofer in the originals speaker hole for the screws, but other than that all good , it works great and the quality is not like the original but it does its job, which is good

フォステクスより音楽的に鳴っているような気がします。