

🔒 Lock in your vibe, play without limits!
The Jim Dunlop ADU 2PSLS03 Straplok Retainer System offers a secure, easy-to-install locking mechanism for guitar straps, available in three stylish finishes to match popular hardware. Engineered for durability and global compatibility, it ensures your instrument stays safely strapped during every performance.















| ASIN | B0D63B4K2K |
| Customer reviews | 4.9 4.9 out of 5 stars (1,922) |
| Date First Available | 4 June 2024 |
M**G
strap button with which you always know what you are doing
C**N
Nickel, ne s abime pas ds le temps
J**.
Highly recommend! I installed these on a Les Paul. Larger diameter than stock buttons. Plenty of room for a silicone washer. Guitar is much more secure with these buttons. Quality is top notch! I used the original screws.
A**R
🎸 I bought these as I had used them before and was satisfied with both the construction and the finish. Some cheaper alternatives are noticeably smaller, and from the images, it is clear they would press into the instrument’s surface when fitted, even with the felt protection. That is not the case with these. They cost twice as much, but the secure fit and the fact that they will not damage the instrument make them a far better option. The only drawback is the screw supplied with the gold version—considering the finish, a brass screw would have been more suitable, or at least one with a matching gold finish. It’s a very small point as you cant see the screw very well once installed. 🎸 I found the strap button slightly larger than many of the smaller versions available, which makes the strap sit more securely and reduces the chance of it coming loose. Fitting was straightforward, though it requires care, as there are no instructions included. The biggest concern is preventing damage to the finish. Before installation, I checked inside the instrument to confirm that the tail block was thick enough for the screw and correctly positioned. Mine was offset by about 5mm, though not enough to cause a problem. 🎸 To install, I marked the desired position and placed a piece of protective tape over it—avoiding clear tape, which can be difficult to remove cleanly and is not robust enough. I drilled a 1mm pilot hole to match the screw’s depth, measured with the button, screw, and felt assembled. This was then widened to 2mm, then 3mm. To prevent the screw from damaging the finish or the centre seam, I drilled the outer layer to 3.2mm to a depth of 2mm. The screw went in smoothly and held securely. The opening in the button is wide enough to accommodate a standard screwdriver head without issue. As mentioned, I have purchased these before and will again. ✔️
1**3
ロックなしでストラップも使えてとても良いです。 某S社のは先端でソフトケースに穴が開いてしまうので、こっちが良いです。
Trustpilot
Hace 1 mes
Hace 4 días
Hace 5 días
Hace 1 mes