DNA MOTORING Pair Headlight Assembly Compatible with 2003-2006 Chevy Silverado 1500 2500 3500 1500 HD 2500 HD Avalanche 1500 2500, w/o Factory Cladding, Chrome/Amber, HL-OH-CS03-4P-CH-AM

These headlights have been nothing but great! Very good value for the money, function as should, and are super easy to install. Haven’t leaked any for me but if they do i will definitely be ordering more. Super bright and look sleek!

Great fit, pretty inexpensive and made the truck look way better

Great buy, good quality, so far the seal is tight no intrusions, clean and clear and fit perfect on my 2004 avalanche Z66

As others stated they don't seem to fit perfectly. Super easy to remove and install. The bottom light seem to want to pop out. The clip in part is not made correctly. We drilled a small hole above the clip and put a screw thru each to keep them from popping out of place. I have noticed some dew in a couple in the mornings. I'm going to reseal. Probly should return and pay $20 more for some with better reviews... we'll see. If I don't in a few weeks the sealant worked. But with having to buy caulk and get extra tools out, like I said you might as well pay a little more. These did not come with bulbs so you might want to check yours out and grab some new ones. Might as well while you have them out.. also got out the newspaper and tape. Painted my chevy emblem and faded plastic. My truck is looking good. Now to find a good deal on wheels and tires. 😣🙄😂

I have a 2006 Silverado 3500 that I bought recently where the headlights were so glazed over I couldn’t even see at night. I bought these and found that the fitment was very tight but in the end they look amazing. I was having trouble putting the pen in the hole on the top headlight, it seems that diameter is just Slightly too small. But it does finally push through and it holds in secure. Even if these last me only a year or two, they would be worth it for me because the quality looks very nice and also has a great projection on the ground with the light.

Cheap China crap, To begin with the passenger side headlight kept popping the low beam headlight fuse and I got out my multimeter I found the molex plug wires were populated backwards (negative wire was in the positive spot and vise versa). Next the middle headlight bulb was inoperative, upon further investigation I found a two wire white molex plug inside the headlight housing to be unplugged. Fishing it out to replug it in was next to impossible due to the short wires on both male and female sides. I did like that the wires were marked so knew what they went to but if I didn’t a factory wiring diagram knowing where to tap them in would not have been any fun. So once I had the passenger headlight and both turn signal lights installed I got the drivers side headlight out of the box and found the light housing on the inside of the headlight loose and flopping around, upon further inspection I found the cup side of the ball joint style adjustment fitting damaged and there was no way of repairing it due to it being on the inside of the headlight housing. I was very disappointed after about three hours repairing and installing just to remove them and return them due to bad assembly. (The pictures attached the white plastic cup inside the headlight housing is broke and missing a part of it. The black ball should be snapped into it.)

This was an easy swap . Mild trimming of plastic tabs otherwise a good fit. Clear and bright.

2007 Chevy Silverado Classic -Fit fine, look great! LED bulbs installed also.