TotalBoat Aluminum Boat Barrier Coat (Quart, Gray)

I am painting an old outboard and wanted to seal it with primer. You have to mix this epoxy primer precisely (3:1) so I bought a cheap little food scale to weigh it with. Turns out it's 3:1 by volume, but 5.6:1 by weight, so imagine my shock when I discovered I had 1/3 of a can of base remaining, but no more activator! I called Total boat, and Jamestown Distributors, who make the product and explained the instructions on their website says weighing is the most precise way to measure, but you have to really hunt to find the differing ratio instructions, and now I have an unfinished project. They agreed, it's confusing, and they're sending me a replacement! I can't say enough great things about their customer service. I'll be buying all my marine paints and primers from Total Boat.

We had our pontoon boat out of the water to refurbish it. I sent photos of our electric motor shaft to my nephew who is a sailboat rigger for advice. It was looking corroded. He recommended cleaning the corrosion off and buying this particular product for protection. It is like a thick paint and was super easy to apply. For sure it will give our motor years more of service. Worth the cost.

1000% reccomend this. I bought this as a precaution to help stop any leaks that nay or may not happen. It popped up when I google waterproof barrier undercoat for a boat. This product is not rated to be waterproof I later found out but once I applied it I felt super happy it went on perfectly to my aluminum 16foot boat. I do reccomend getting a top coat for once it drys. Use inside as well if you can

Just got off the phone with my guy whos welding aluminum. “Jesus guy, what kind of primer you use on this!? I had to sand and torch it 3 times to get it off!” Gave me a good laugh. This stuff is pretty tough. Application was easy as long as you take your time and prep it correctly. Pretty happy and If i decide to totally restore another flat bottom in the future(NOT likely) I will be sure to purchase again.

My pontoon was having corrosion problems. I found this product online used it on the pontoons was a little skeptical if 1 gallon would be enough, but I had enough to do two coats love the product. Very easy to use caution even outside. Vapors are very strong. Probably need a mask.

Used to prime and protect a boat project. It goes on very thick and rough even when thinned out. Reminded me of bedliner. But that could of been the application process. Cheap airless gun. It did cover well and did a total of 4 coats.

What a great product, just a few things that helped me... It is going to be too thick out of the can. drill mixing attachment to mix the base and hardner together. Thin 10% with totalboat 200 thinner and roll it on with a bunch of small foam rollers. Wear a good respirator, probably too dangerous to spray without a full force fed suit as I have read these epoxies in aerosol can damage your lungs real bad, not worth the risk.. It etches and bonds to even lightly oxidized aluminum. I quit sanding and just washed clean and applied, seems to be holding up no differently than a lot of sanding...

We have a 15' stock tank pool that our kids "swim" in during the summer. I keep chlorine in it, so last year it began to rust. I tried sanding the rust down and using flex seal, and that flaked off almost immediately. So this year we, again, buffed out all the rust and used this, and it is working incredibly well so far!! It covered the bottom of the 15' pool thinly and about 6" up the pool wall. I would like to put on another coat this fall for extra protection, as the can calls for multiple coats. But this was a great solution to our problem!!