Brilliance Laser Inks 50 Grams Black Metal Marking Powder with Foam Brush | Permanent Durable High Contrast Laser Engraving Accessories for Fiber, YAG, and CO2 Laser Engraver BLI101MBPWD50

Likes: easy to mix, and works well with my laser engraver. I should have gotten the pre-mixed spray. At first I tried using it as shown on their website, brushing it on. I wasn't sure how thick of a layer should be used. I gave gotten better results by mixing it in a spray bottle, and spraying it on. So, just buying a spray can would have been easier. I am curious just how dangerous this stuff is - the first few times, I was careful to wear rubber gloves when using it. After forgetting to put on gloves and not noticing any ill effects, I have been using it without protective equipment. I only use it occasionally, for my laser engraving hobby, so maybe the precautions are more relevant if you're using it all day every day in an industrial setting?

Awesome worked great

Don't buy this look for titanium dioxide think it's 30$ for a pound package. It gives better results on all matearials just mix 1:1 with 99%iso

ALLGOOD!

This was just a piece of ceramic tile I had in my scrap pile. This is about a half dollar size and took about an hour. Mind you I only have a 10w laser so I have to go very slow with it. I laser engraved this with the powder mix just as follows. Did a perfect job on my first attempt! Very much recommend!!!