SMALLRIG A7IV ZV-E1 A7CII A7CR A6700 Screen Protector for Sony Alpha 7 IV/Alpha 7C II/Alpha 7CR/Alpha 6700/ZV-E1, Screen Protector Protective Film 0.4mm Ultra Thin Tempered Glass (Pack of 4) - 3750B

I never use screen protectors on phones, probably because of OCD - I couldn't handle any bubbles or other naffness. Figured I'd give these a shot rather than take my camera shop's advice and chop up a phone protector. Well worth it, the fit is perfect, no ragged corners (like my ham-fisted scissor skills probably would've resulted in) and practically indistinguishable from the bare screen. Actually very good value for money getting four in the pack, now I just need another three A7 IVs to stick 'em to!!

Using on my Sony a7600. I normally buy the manufacturer screen protector when I can as I've found them to be high quality, but due to timing I thought I'd give the Smallrig ones a try. So so glad I did. Amazing quality and very easy to apply with no air bubbles, I'd even say it felt easier than the manufacturer ones I have used in the past. Can't recommend this strongly enough !

Easy to fit, matches screen well and lasts well.

I bought the Smallrig screen protector for the Sony A6700 after realising that due to it's small factor and more limited buttons and dials, I needed to use the screen a lot to change menu settings and other adjustments. This meant the screen was more exposed a lot more than on my other cameras. The screen protector is very easy to fit and even adjust if you don't get it right on the first go. Just follow the instructions very carefully and avoid fingerprints in the adhesive side of the protector.

Perfect fit. Very easy to apply. Good price. I would purchase again.

Well, that was a right party! In the absence of any usage instructions in the pack I wrecked two of these before finally getting one to stay put without bubbles. Yes, there was a tab on the glass saying - in microscopic type - Back, please peel off the back with this sticker. So that's the back of the glass right? The side that's exposed when it's in place and the peel-bit is for protection from sticky fingerprints while you get it placed? And yes, partial bubbly adhesion is achievable on the other side. But works a lot better if the peeled side is applied to the screen instead! All that said, these really do seem pretty good quality.

Good fit and easy to apply, touch screen still working as it should.

Easy to fit, no bubbles, still perfect 3 years later.