BOJACK Low Voltage DC Motor Speed Controller PWM 1.8v 3v 5v 6v 12v 2A 30W Adjustable Driver Switch 1803BK 1803B (Pack of 2 Pcs)

Prior experiences with Bojack products have been excellent and this is no exception. It is not a potentiometer but an easy to use power regulator that works very well with a Practical design for hobbyists.

Works just fine

I burned out the factory one in a 12 v fan. This resurrected the fan but did not fit in the old cigarette lighter plug so I had to McGyver a small box to enclose it. The fan works again though.

I installed this on leds strip white lights. Everything I have done is correct, as in power from battery ---->to the fuse----> to the on/off switch and finally to this voltage step down or up. The lights lights up and dim down...... but with NO power to it and deactivating the on/off switch, somehow it still sends power to the lights. If i turn up the voltage when switch is OFF it finally shuts down like it should. Its a mystery

Great product, works well and last

This little gem works as advertised. I use it for a custom n-scale turntable setup and it's perfect. Very easy to control.

Electrically, the two I received worked just fine. I'm using one to control a small fluid pump, the other for a blower motor in a small filtration system. They perform well enough. The fluid pump runs 15-20 hour duty cycles at 3.3-6V and about 1-1.5 amps. The blower pulls less. Neither has had a problem with the controller. My only negative issue is in the quality of the assembly on the PCB itself. Neither knob was mounted level to the board, which made the knobs sit cockeyed compared to the face of the control panel. I had to remove and resolder both, so, minus two stars for the added sweat equity.

Not true pwm generators. They are specific frequency, but change duty cycle. So far so good. Cheap enough to replace if they quit.

One worked good the other didn't work at all

The speed control doesn't consistently work between the 2 I was given. The knob didn't fit tight and falls off.