ANYCUBIC Replaceable High Density Activated Carbon Filter for Most Mini 3D Printer Purifiers (Pack of 4)

Good replacement for the filter that came with my purifier. only bad thing is that these things are brittle and will break if the air filter drops off the table.

I have been using it to absorb the ABS printing fumes in the Bambu X1C. I put two filter units laying flat on their backs on the bottom and print. Really cuts down on the fumes. Highly recommend.

Great replacement filters for mini air purifiers

Make sure to use gloves when installing these, but otherwise they are great filters.

If you install this inside your printer it does a good job filtering the air

A few years ago I switched from getting Anycubic printers and resin to Elegoo because they seemsd to have better after purchase support and replacements. I never imagined I'd be going to Anycubic to replace filters in my Elegoo purifiers!

These things work beautifully even if you have a standard FDM printer and not a resin printer. It cuts down the ABS smell from the entire room to only around the printer area with just one of these little purifiers. They sell them in a two pack for 20 bucks and they are worth every penny The only downside is these filters are very fragile as I just discovered if you basically look at them cross-eyed they will break. Open the cover, replace the filter, put cover back. Then carefully put this back where it was.

First off I did not purchase any of these replacement carbon filters. I did purchase two sets of the Anycubic air purifiers since Elegoo hasn't released any replacement filters. These are exactly the same as the Elegoo.