2PCS 50 ohm RG58 BNC Male to Female Coax Cable - 3FT Low Loss Antenna Extension for CB Radio, VHF Ham Radio, Wireless Microphone, CCTV, Amateur Radio

They work as expected

It’s like a glove

Half the cost of Senneinsher branded relocation kit for IEM G4 units. Worked perfectly!

I used this in a wireless microphone rack to connect between the outside of the case and the internal distribution amplifiers. This lets me plug the external antennas in without having to dig around in internal cabling. The rack is a 6U "plastic" Gator rack that gets moved around a lot, but I mounted the connectors in the handle recesses so they won't get damaged. This is the 2nd rack I've done this on -- the last one used flange-mount BNC male-to-male and, while it works okay, adds another set of connectors to the system that this set eliminates. The connections on both sides are nice and solid with no play. The threaded flange mount went on smoothly with no cross-threading. I tested the cables before I installed them with my Nano-VNA and they measured at 49.24 Ohms at .37dB insertion loss for the frequencies I'm using (500-700MHz), so that's perfectly acceptable for the use case I have.

These work rather well as extensions for my oscilloscope probes and function generator leads

Nothing negative to talk about, these 3-foot BNC male to BNC female jumper cables are exactly as advertised. I needed a short jumper on my bench for extending the reach of several pieces of test gear, this looked to fit the bill and after testing, they function great. I thought I’d sweep them and show some data to support my opinion. They appear to have factory-placed ends and heat shrink to reduce the stress of bending and use. The images I attached are sweep results with a spectrum analyzer, from about 10KHz to 1.5GHz, you can start to see a small amount of roll-off above 1GHz which is not a problem as I needed cables to operate in the VHF and UHF frequencies. I’m delighted with these; they are a good addition to my test bench.

High quality cables with solid BNC connectors. I got the two piece bundle, they are 3 feet each. Understand what you're buying! Not too many electronic devices in the US use BNC connectors. I have a TV transmitter that has a BNC port an antenna with a BNC connector as well. By connecting this cable, I'm able place my antenna exactly where I need it to be. Love these cables. Just what the doctor ordered! 5-Stars!

These look like really nice cables, good heat shrink on both ends and smooth fitment to other BNC connectors I had on-hand here. In the video I was confused thinking I had ordered 2 foot cables but after recording I went back and checked and saw it was for 3 footers, so I got exactly what I was supposed to get. The panel mount ends are really nice.

Todo bien, cumple con su propósito.