1-Part Epoxy Acrylic Concrete & Garage Floor Paint, Slate Gray, Satin, Interior/Exterior Concrete Paint for Basement Floors, Porches, Driveways & Pool Decks, 1 Gallon

Great to cover a DRY, relatively unused cement floor. This paint is easy to apply and two coats covered 100 square feet. VERY easy to clean up in a sink. I like the matte grey color and texture. I would not use this paint and expect to be able to drive on it and turn the wheels of a car without the paint showing damage. This is good quality paint, but this is not a professional epoxy garage floor paint. If your garage floor is built on the ground and doesn't have a significant vapor barrier, don't expect this or almost any other floor paint to stick as the water will ultimately win the battle.

Was a little leery but was willing to give it a chance. Started out butting it down as a border and was being a bit too conservative with the application. Didn't realize this until I had let it dry. I was a bit more liberal with the roller and it turned out really well. It says two coats but I have to tell you, one coat looks great but I will do a second coat. I did not pay close enough attention to a couple of areas and didn't realize it was still wet. After completing the job, it became very obvious where the invisible wet areas were. Looked like glass while the dry areas were fine. Applied heat to the area then covered with a tarp to protect from night dew. Later on, it dried up and looks great. Cracks were a problem. They retained more moisture and it showed. Says it will fill 1/8" or smaller cracks. Well, not on the first coat so I will be generous on the second coat. If they still show, oh well, filler, grind and repaint area.

This goes on well. Looks great. My only complaint it peeks even after a second coat. So that was last summer. 2923. Here it is 2024 and I’m putting on another coat , sidewalk and driveway and we will see how it goes. Works better than most paints for concrete. Will continue with order.

Great paint used it to paint my driveway and holds up a lot better than other concrete paints I have used

Followed directions precisely. Prepared the unfinished basement concrete as directed on the can. Applied one coat to the prepared unfinished concrete, it didn't even cover it, the concrete shows right through. Waited as advised in instructions and applied a second coat cross-ways... looked better but there were still areas where the bare concrete still showed through. What the heck??? OK so I applied coat #3, and that finally did the trick, left it to cure for a week and now it's peeling off in big patches, showing the concrete below again. Yes I prepared the concrete as directed, and yes, I've been using paint for over 40 years, this stuff is just sub-par. I give up.