VEVOR Hydraulic Strut Spring Compressor - 4.5 Ton/9920 LBS Jack Capacity, 1 Ton Rated Compression Force, Auto Coil Tool for Removing

Works great. Well made and best price anywhere. You ABSOLUTELY NEED to make a wide base to use this stand. I have attached a pic. The stand is heavy duty, but the weight of a shock would tip it over and especially when trying to loosen the cap nut on a coilover, it would tip over. Having a base would also allow you to stand safely behind the press while working.

This tool is amazing!!! It is really sturdy and gives a comforting sense of safety while performing one of the most dangerous auto repair activities. My only negative comments are about the directions which should state that 1) make sure that you allow enough room (use the top stop) so that the spring can fully extend when dismantling and 2) place the passenger side strut upside down in the tool so that the tool grips it more securely.

This compressor is utterly useless . Right out of the box it was assembled and the pump cylinder was not compressing . When the trucks coil was installed into the mounts the pump would decompress and you would have to continuously pump the handle to compress the spring. After repeated attempts the oil in the cylinder shot out of the adjustment screw and no longer worked. Ended up traveling to auto parts store and renting a compression tool. Complete waste of money and throwing it into the dumpster. It’s not like you can wait around for a replacement when the vehicle is in the air and front suspension is disassembled. Very frustrating to stop everything and go out and get a tool that works .

Worked nicely for occasional home use. It is quite strong, but the a bit too fussy for a commercial shop. Adjustment of clamping height, swapping out sizes of clamps and securing of the safety cables all require nut and bolt fasteners rather than quick change pins so it takes a bit more time to setup and use. I'd buy it again.

Very easy to set up. Product was a little unbalanced. Cheap and looks like it a reasonable product

Works like it should,

I like this product. It's easy to assemble, sturdy, and the powder coating is nice. Good product.

Does the job, but not sturdy enough for long term use. Good enough for someone working on their own cars occasionally. Spring holding "forks" are sized for larger diameter springs and did not fit smaller diameter springs well (Subaru BRZ).

Used it on titan front springs,work pretty good especially for the price.

This press makes fitting car springs easy to install. Quality item and value for money. I should have bought one years ago. It works exactly as it should and a lot safer than using clamps. It’s the perfect size and sits in the corner of the garage until needed.

Super outil. Facilite grandement la compression du ressort afin de remplacer l'amortisseur. Utilisé sur bmw 130i . L'outil est bien fabriqué, solide, il y a même 4 joints de rechange en cas de fuite de verrin. Franchement je recommande à 100% et vu le prix foncer sans réfléchir.

Parfait ,fonctionne super bien

Attrezzo ben fatto, resistente, facile da usare e lo trovo sicuro. Ottima qualità prezzo. Lo consiglio