48V Battery Equalizer, Active Balancer for 24V/36V/48V Bank, Supports for LiFePO4, Lead Acid, Gel, FLA, SLA Battery, Perfect for Home, RV, Solar, Trolling Motor, Off Grid

I bought this when I bought with first 4 12.8v LiFePo4 batteries that I wired in series for 51.2v. These batteries were to be used with a solar inverter to power my house during outages. I read all the warnings about batteries in series becoming unbalanced over time thus affecting the longevity of the pack. I figured an active battery balancer would be perfect keep everything in line. After my research I settled on this brand. The reviews appeared good and the brand from what I understand was reputable. I charged all the batteries in parallel to 100% first, let them sit overnight then proceeded to connect them in series. The instructions say to install the leads from left to right and that's what I did. The next day, one battery is 200mv lower than the rest. The next day another battery is 60mv higher than the rest. This cycle went on for weeks. They never balanced. To make matters worse because it couldn't balance it never stop running draining my batteries very quickly. What's ironic is after I uninstalled it is when my batteries achieved balance. I've also used this on another set of LiFePo4 in series and had the same result. I'm just going to assume I got a defective product as I'm seeing reviews saying it works. Update It turns out the one I got was defective. Support reached out to me and we went through several troubleshooting steps. After determining that the unit was indeed defective they sent me a new one free of charge. Been testing the new one for several days now and it works flawlessly. Thanks LiTime, I will definitely recommend.

Works very good for my 48v

Use these on my solar setup running four 12v to make 48v and have been keeping the battery’s in balance,

I installed it in 15 minutes. Take care to leave the negative lead protective covers in place until final connection. I had planned to install a 10a fuse for each pos lead so that I could disconnect easily if needed. However, the thing just works! I have seen no excessive draw as other have noted. I have checked every day or two over the past month and the voltages are always within 10mv. My overall efficiency and capacity have not been adversely impacted. I can now take it safely down to 10% without one of the four LiTime Mini's disconnecting for low voltage and shutting down my 48v system. This is about 6-7% more than before the balancer. This balancer is worth the money.

Support is the worst in the world. They told me to connect in a way that would short circuit my batteries. Not sure if support is AI or just an incompetent person. If I didn't double check what they told me to do, I could have died. Be very careful trusting support. With that said, the noise is crazy bad. I installed it in my van and cant sleep. It has this super high pitched noise. My dog wont stop barking when its on. I cant sleep with it on. It does seem to work at least, for me. It balanced my setup within 0.1v. So if this is just gonna be in your basement, where you cant hear it, and you dont need or aren't the type of person to contact support, then you might be able to use it. Otherwise, there are better options. Would not recommend.

Way easier and works 100x better than the three Victron balancers it just replaced. 48v 4S3P.

A MUST HAVE for batteries in series to maintain equal voltage distributed across each charging & discharging. This is the best unit I've used to date in multiple installations.

My inverter for my solar system kept shutting off because of battery inbalence issues. I purchased this ballencer and installed it and have had no further issues it has been working for a couple of months now.

All 3 batteries have stayed pretty much the same since connection, works as it should! Update: ordered my second balance,the package arrived empty but Susan at Li Time was prompt to act and my second(third) arrived it will be hooked up to my second bank of batteries later today. The package was shipped in its own box for the third time with still no seal,anyone can easily take the unit out of the box during shipping and no one would know where it disappeared!!!

First off, what I like about this device is heavy and looks sturdy which gives me some confidence, but the most amazing thing is it works as I heard from others. I just set it to my 2 12V batteries connected in series and it leveled the voltages in both with 2-3 hours

I have not sued it yet because it has a strong smell out of the box like burnt rubber or plastic. It could be normal and from manufacturing but seems a bit strong. Is that normal?

Dont waste your time its useless Chinese garbage

Did job i needed!