MerriwayBH02984 (2 Pcs) Replacement Handle for Washing Machine Isolator Tap Blue - Pack of 2 Pieces

Just as ordered, fitted perfectly & tap working again now.

Nice product does the job that they are intended for.

Fits very nicely on one of my valves but not the other.Not sure why.

These fitted an existing isolator tap that had became brittle and snapped off previously, thanks.No screws are included, so ensure you keep the one already that would have bee on the old one, if you don't have a screw, it is better to order a complete replacement fitting altogethercomes in a 2-blue pack, now i have a spare one for future, but rather have had the option to have one of each colour instead, but most cases it is just a blue one that most washing machines now use just cold water anyway from the supply, then heat it in the machine.The older one i replaced wasn't exactly 100% the same colour or design on the top, but the important part is the lower fitting, which is the same for all of these styles of handles and all work exactly the same way.

To replace a broken handle. Straight swap, took 1 min. Note, screw not included, so keep your existing one.

These were just the handles I needed, but they're not extremely strong. I suppose if you're not going to be turning the isolator on and off then they're fine but as we've got a leak further along the pipe, we use the isolator daily and two handles lasted barely a month!! However, for less than £3 I won't complain.

Handyman broke the old one turning off the water supply to my washing machine then buggered off. Searched Amazon & these were the cheapest replacements. Worked exactly as they should, no issues. Have one spare for next time! Could benefit from a wee instruction insert: you have to remove the screw from your 'tap' then put the plastic handle in place before replacing the screw through the handle to secure it. Simples!

These handles for pipe valves are of very poor quality! I was tightening the screws very gently, and both of them cracked! It’s obvious they were 3D printed, and naturally, they can’t be strong. Also, the two inner ridges are too large, which makes it difficult to turn them when closing. Avoid! I’ve learned it’s better to pay extra and buy metal ones.