KUAFU Windshield Wiper Cowl Cover Panel Compatible with 2015-2020 Ford F150 Replacement for FL3Z15022A69B Left & Right Front Windshield Wiper Cowl Grille Insert Panel

Installed on 2016 F150. It's a relatively simple install, and you can DIY it after watching a video. The tubes to the wiper fluid spigots are a little short, I wish they were a bit longer, but it fit with some finagling. The spigots are adjustable once you get it installed. Just direct them with some needle nose pliers. Makes the truck look much better, and you don't have to fool with trying to restore the black, which can have fair-to-middlin' results. Over time,it settles in, and the fit gets better.

This cowl fit perfectly. Come with all clips and washer hoses. Quality replacement, hoping it last the 6 years the OEM cowl did. 2017 F150.

Great quality and easy install. I don't give it 5 stars because one of the water nozzles seems to be clogged or won't spray properly. I wanted to install the one I had before but it's a different size and won't fit this replacement.

Great product fit was excellent and looks great on 2015 Ford F150. Easy to install

I'm glad I bought this, it looks like a factory part and went in fairly easy. I live in the woods in North Florida and it felt like 100 degrees and I had black gnats flying around my face so it made the install a little annoying for me. if it was overcast and in the 70s it would have been a pleasure. Anyway, the old one was shot from the Florida sun and the gasket against the windshield was all cracked up and falling apart. the old one came out OK, connected the included new hose to the new sprayers and the snapped right into place, connected the new hose with the quick connect on the end to the existing hose by the tank. turned the truck on and checked the sprayers, a little low, these can be easily adjusted with a small fine bladed screw driver, pointed them up a little and done. I can highly recommend this aftermarket part. just take your time putting the new one in and make sure the front and rear clips go where they need to go and tuck the rubber in at the ends near the fenders. Add edit: I was going to paint the wiper arms because they looked awful too but after wiping them down good with acetone and alcohol they cleaned up nice.