2 GPM

I've only had it a few days so far, I have it pumping water to my greenhouse mister system using hose reducers and 1/4 black drip hosing and assorted 1/4 push to connect fitting(RO/DI). Runs quieter than my older smaller pump and sends plenty of water through the 1/4" hose to the misters. One con is the pressure screw is stuck and can't adjust it, screw stripped. Still works great and suited my needs. Thumbs up so far.

Worked for our farm sprayer

Almost gave this one Star and sent it back. This pump works with the following caveats. 1) will not work if you install it upside down. 2) has extreamly poor suction if it's installed flat 3) if the pickup pipe/hose is longer than 3 feet then it will take for ever to self prime. Even if the supply is level to the pump. Recommend that you use a fairly rigid 1/4 inch hose between the pump and the water supply, 3/8 or larger will cause issues because of the low suction.

After using my Ironton ATV Spot Sprayer several times, I determined that the 1 GPM sprayer pump was just too small. On May 18th I purchased a Bayite 12V 2 GPM pump and installed it. The Bayite pump comes with everything you need to install it to the Ironton; all of the Ironton hoses match the fittings on the pump. There is nothing else to buy. This new pump makes the Ironton ATV Spot Sprayer an excellent sprayer for only an additional $37.99 and about 1 hr. to install.

I bought this to make a misting system for my bimini top on my boat. the pump is a little noisey but I installed it inside the cooler I am using for the water source. it is quiet enough inside it and works great so far and lasts enough to where I can use it intermittently on hot days to keep me cool when fishing without draining my battery too fast. I did have to turn the pressure down so it would not cycle on and off constantly.

The pump worked fine (although loud) for the first couple months. One day it started running but sounded different, like it was not building pressure. After less than 60 seconds run time, the pump was hot enough to melt the plastic case away from the pump body. I'm fairly sure that the pump would have started a fire if I had not been there to intervene.

I purchased this to replace the worn out pump on my 15 gallon harbor freight sprayer. Installation was easy... beyond easy. Screw pattern didn’t match but I drilled some small pilot holes in the tank and used the screw from the old pump. Worked great. Way more power than the original pump. Worth the money.

Replaced the 1 gallon pump on my 8 gallon sprayer with this unit. What a difference it made in the discharge of spray material. Now, using a boom, I can keep pressure up to where the nozzles work like they are supposed to. Would buy product again