6" Vise Jaws, Universal Soft Vice Jaws Pads Covers with Strong Magnetic, Multi-Purpose Protector for Any Metal Vice, 1 Pair, Black

Good quality, feels sturdy on my vise and good design, no cheesy colors. I already test it with cutting small plastic tube, it holds very well. I wish magnets where a bit stronger, but they good enough to do the job and not fall off. I'm using these on 3-1/2" jaw vise and these pads are 4" wide working pretty good for me. I was able to slide off rubber pad from metal holder for cleaning, that is a very good feature. I would recommend this product!

This is a very well made and nice product but note that this absolutely will not work correctly with a Wilton 4-in device because the magnets line up exactly perfect with the screw holes that bolt the jaws on the device and it doesn't get a good magnetic connection. But they are very well made and I really wish these out of work. If they were only with larger magnets or if the magnet went all the way across they would be perfect and an excellent alternative to some of the more expensive ones

Fits easily and provides good protection, magnets could be a little stronger tho.

They work great for protecting

I don’t know why I haven’t ordered these before. All these years using an old towel or rag to prevent marring whatever is in the vice when I could’ve used these. The four inch ones fit the jaws perfectly. They have good strong magnets that keep them in place and come in a nice variety of colors. I got the blue ones and they match my vice nicely. Very good value for the money. Hope to get years of service out of them.

These fit easily on my vise with the magnets (3 on each soft jaw) holding them in position. Soft material, hard surfaced enough to hold an object securely but not leave a mark. As luck would have it I had a use for the soft jaws the next day and where the cut-steel of the vise would have ruined the project the soft jaws worked far better than trying to improvise with cloths or rubber strips. A great addition to any vise as long as you've taken the effort to even get a vise to hold your work, the range of tasks you can handle is much greater.

My vice is a 5" so I cut them down. I liked was that the rubber inserts slide out making it easy to cut the rubber about a centimeter larger than the metal to allow some overhang. The location of the magnets allowed the cuts to be made without contacting the magnets or needing to cut both ends. The rubber is tight enough in the aluminum that I wouldn't worry about it sliding out in movement or shifting, and its almost dense enough that anything cylindrical shouldn't make contact with the aluminum to cause marring. The rubber does have a slight tackiness. The two plates stick to each other when pressed with nothing in between and they also stick to your clamped object after unclamping. So I put a dry lube with teflon on them in addition to new magnets. My only issue overall is the strength of the original magnets. I'm not sure what they are made of. They chip, they spark, they aren't black like most chippable magnets. I tried them on my 30 year old super duty 360x360 bench vise and on my new heavy duty 360x360 and they stay on against plain gravity but can easily be knocked off if the vise gets bumped or they themselves get bumped, or you didn't keep the rubber either oiled or dusted depending on if you work with metals or wood or plastics. But, as a fabricator, I buy rough ideas and then I make them up to par myself. Seeing as I dont have an aluminum caster, or a rubber caster, nor a electrical magnetizer, but I do have access to a hacksaw, a drill and other magnets, these are great. Cut em to length, pop out the old magnets, adjust the holes and glue new magnets and bam, ready to work for you for a lifetime.

Works As Expected.