Suspenz SUP Storage Rack, Stand Up Paddle Board and Surfboard Rack with Safety Straps

The racks are great, after searching and reviewing all of the different types on the internet I decided to spend the extra money and get these. I’m glad I did they are very well designed and made, easy to install and look great. Instead of purchasing the double hanging set I went ahead and purchased 2 of the single sets and then the Extension Bracket kit. This saved me about $30 over buying the same kit they sell of all the same thing but all in one box. Being I will use these outside on our lake boathouse I went with the regular steel set with powder cat paint versus the saltwater galvanized painted set they offer. It should work just fine here, they came with all of the mounting hardware needed, very good instructions, 3.25” mounting screws are very long and an offset screwdriver to help install it. The hanging straps are 1.5” wide, very thick webbing and are fully adjustable from the bottom ends via Velcro so you can shorten or lengthen your top clip easily. Great design and well supportive.

This is not for a Kayak. Unless your kayak is 12" in profile. It is for a SUP or surfboard to be securely tightened down. I have mine outside on my dock that has high winds at times. It is easy to install with the correct tools. The comments from the person saying it is too hard to put in the screws had this difficulty because they did not use a phillips extension (at least 7 inches) to get the proper angle on the head. ** Review after almost 2 years outside on a freshwater lake dock - The rack for my paddleboards is holding up well and used many times per week to put on and off the paddleboards. Its very sturdy and the straps are holding the boards in high winds well. The bolts that are used as the holders of the straps are standard carbon steel however, and they are rusting. If this was in a salt environment, I suspect that there would be much more rust. I am very satisfied with this, and the other model that holds my kayaks. Dont assume that this is a kayak holder, because the name is wrong. It will not hold a kayak.

Easy to install and sturdy. The only gripe I have is that they send somewhat large lag screws for the mounting. I stripped the first two out and then just went and bought lag bolts to mount them. Otherwise, a great mount.

So easy to intsall, works great!! Now my SUP will be easier for me to access so I will go on it more! So happy with this purchase!!

Works great! Exactly as described. I'm using it for my inflatable paddle board, it fits in the rack perfectly.

This is a good product that has potential to be a great product. There is a simple design flaw: the lowest mounting screw is below the front arm of the unit essentially preventing a drill from gaining head on access. Probably no biggie if you’re placing a screw into a 2x4 but it was no easy task mounting these units into concrete. If you have any experience placing masonry screws, you never want to pause or jump off the screw head as the screw tends to strips out. I did eventually get these units hung after a lot of cursing and with considerable damage to the paint job. Clearly whoever designed these units likely sat behind a computer screen and has never lifted a power tool in their lives. I could easily give this product 5 stars had a little thought gone into alignment and access to the mounting sites.

This worked pretty well for my hand made board that I wanted to showcase on my garage wall when I wasn't using it. The Straps need a little more range ( to tighten down ). The board is 11'8" and due to stud locations, the brackets are mounted where they have to be. Also - note that I added some padding to the brackets - I will probably do something nicer long term, but the board is heavy (~30 pounds) and about 7 feet up on the wall - needed padding to make sure I wasn't going to mar the board getting it up there on the wall (I rolled the shelves out of the way, set one end in a camp chair (sling chair) and put first one end in, then the other). I'd have given these a 5 if there was a little more protection. I get it that your average foam, or inflatable board may not need it - but in my case, I wanted it.

Bought one last year for our paddleboard and when we picked up a 2nd board this year it was an easy decision to get a 2nd Suspenz rack also. Easy to install, holds up well and looks good

Solidly built, this rack met all my expectations for my stand up paddle board. Easy to install, and I really like that the board sits in a sling instead of in metal. Highly recommended.

This product is the best quality SUP wall rack I have seen, easy to install and looks great.

Perfect for what we needed. We put them on two deck posts and they look great

Just as advertised. good quality and works well. I'm really glad we bought this, it keeps my paddle board off the floor and well tucked away in the off season.

Mounting holes were a little awkward to get to and I had to use different mounting hardware because I was mounting to a brick wall. I would have liked to have a little more opening in the J and a little more adjustment with the straps because we have an odd shaped 14 foot racing SUP. Also, I added U-bolts to be able to attach lockable straps. It won't prevent a motivated thief but it will slow them down a little