Fire Pit Glass Wind Guard

We are very happy with the quality and appearance

Easy to assemble & works great on propane fire pit; very heavy duty tempered glass

Made my own concrete table fire pit and needed a wind block. This was the perfet size and does great with blocking wind.

Easy to put together and works great

Very well made. Fits on my fire table just fine. Only if side glasses are made to 9 inches would be perfect,rubber feet seats on a firepit frame but it's not burning. I wonder if they sells spacers.

If you are reading this then I don't need to tell you what this does right? So let's get right to it then. The tempered glass panels are thick and free of distortions. I'd say they're about 7mm thick. This thing isn't a light weight and should hold up well outdoors. The size fit our fire pit perfectly with about an inch gap all the way around the gas tray. There are rubber feet to raise the glass about a quarter of an inch thus allowing air to feed the flames. Since glass and metal brackets don't bend, assembly can be a little tricky especially if some of the sand casted brackets a slightly out of spec. Make sure each bracket is facing the correct way, as four have threading for the feet and four do not. My recommendation is to finger tighten each screw leaving some wiggle room to get the last glass panel on. I had to use a little WD-40 to get it to slip onto place. Once it's all together, then I proceeded to tighten snugly no over do it, the screws. Install the feet and you are ready to go.

The glass is thick and beveled along the edges. The aluminum connectors are thick and very sturdy. As you can see by the photo, it is a beautiful addition to your fire table. HOWEVER, the metal connectors have no tolerance and are difficult to get onto the glass as they are a very snug fit. I ended up using a rubber mallet to get them on, fearful that the glass would break at any moment. Light taps with the hammer, one side then the next; it took half and hour to assemble! It didn't break, and it is beautiful. Despite the super tight fit, I would buy it again.

The company that built wanted a lot more money than I wanted to pay so I found this item on Amazon. I measured carefully and ordered the item. I came and we installed it in 15 minutes. Perfect!

Easy to assemble. Quite heavy so stays in place during windy conditions

I asked a friend about this item. He bought it and did his research prior to buying. His conclusion was that this item is equal in quality to the OEM factory item but 1/2 the price. Now that I have it, I concur. This windshield is very solidly constructed and looks very professional. It looks like it will last forever. Very happy. If only more items were this well made and this well priced. Few are. This is a Gem.

It fit perfectly! Strong and very attractive!

Arrived in good shape. And works well to deflect the wind.

Looks good.