EGO POWER+ Gutter Cleaning Attachment for Electric Leaf Blowers LB5300/LB5750/LB5800/LB6150/LB6500/LB6700/LB7650/LB8800 - AGC1000

Slips over factor nozzle just fine... Disregard negative comments... Works incredibly well... Slight modifications would fix unscrewing...

Now this I really like. as I'm getting older and do like ladder or climbing on the roof any more. Im in a ranch and can easily reach the gutters

I'm not a typically high rater. To get five stars, you have to do something to knock my socks off. 4 stars means GOOD. I had already investing in a competitor's blower and gutter cleaning system when I picked up an EGO blower fairly cheap. I already had a EGO lawn mower so I had batteries and chargers. The blower was definitely more powerful than the corded unit I had. After messing around dragging cords around I thought I would try the EGO Gutter system. In general, I do like the EGO products. Nothing special about the gutter system; a bunch of ABS type plastic pipes that 'screw' together and attach to a blower adapter, much like my previous system. The pipes are definitely bigger that the ones I already have and they aren't going to be interchangeable. My original unit has a rotating 'cuff' attachment at the point of connection to the blower so you can easily change the direction of the top curved blower. The EGO system does not. In their case, they have a 'pseudo' (plastic indentations) pin locking system at the top that you can adjust the top blowers with. The original unit would occasionally disconnect as I was trying to rotate the correct blowing direction. The EGO is a little harder to pull down and adjust, but it won't disconnect either. Not sure which system I like better, yet. With the original system, I did have to replace a couple of the pipes when they broke at the connector. I'm not sure how EGO will standup for durability. The EGO blower is a definitely more powerful blower and therefore did a little better job than the original. I do have to wear goggles to prevent flying debris with either system and take a shower afterwards! They both got the job done, but I'm liking not having to deal with extension cords!! The EGO is a GOOD product and so far no significant faults.

I started out with extension wands to the power washer. They did not fit so I got on a ladder and it took a while to clean a short stretch of gutter with the power washer as is. so I decided instead of buying fittings to make the wands fit, to buy this instead. At my old house I used to get on the roof with the Ego and just blow out the gutters, but my current house has all kinds of different roofs and separations, and I do not want to get on three roofs. So I searched got this surprisingly light, well fitting and cheap extension. It rained all morning so the debris in the gutters is wet and heavy. I got a raincoat on and some swimming goggles and blew out the gutters on high with boost before the battery was even red. I was filthy and happy! this was easier to handle than the power washer due to lack of cord, lack of garden hose and lack of pressure hose. it is just me, the Ego and the gutters. Plus the Ego has many places to hold on and I leaned it into my stomach for steadiness. walk left, walk right and voilla. The gutter is clean and I and the Ego are filthy. I love the tools from this brand

Product is in perfect condition. Used it to clean my gutters.

I like the thought - I can clean my gutters every week from the debris that gets in there, access everywhere without a ladder....and for that, these work well. Now the bad: 1) The end U-piece is friction fit. I have the 650 CFM blower and since the end U is friction fit and the resultant forces is such that it wants to go straight up you can guess which way it goes when it gives out. I've shot the top U piece onto the roof enough times that I now have it duct taped on. Lots of things in my life are held together with duct tape so I don't mind, but it would be nice if there was a way to lock the top U-piece into place or leave it as friction fit for those of you who have your act together. 2) The individual pieces are threaded. These too need a locking system so that the whole thing doesn't swivel itself loose. 3) Needs a mount for a transmitting camera so I can see what is going on in the gutters. ** 4) Needs a light mount. ** 5) Needs a beer holder. ** Note that items with ** are optional only since while I like Ego products, I'm of the opinion that a good portion of the cost goes into features that are secondary to the function of the product. The ** suggestions are secondary, and totally not needed, but in the spirit of their products I might as well suggest these ideas.

Why a 5* review? Because, EGO products themselves deserve 15*, minus 10* for their factual non existent customer service, which brings it to a 5. So, when I managed to bring all these extension pieces together including the last part which is the exhaust, I gave it a try and after a couple of serious attempts, and failures, I finally succeeded. Preparations are key: one needs a head protection, an eye protection and a good portion of muscles to hold and balance out this thing. Ah, I forgot to mention the ear protection because once connected to my 530 CFM blower head, my blower transformed into an aircraft just before taking off the strip. To my guess in the range of 100 decibel +. Finally, if you suffer from lumbago or arthritis, you need to recover first, or get a good massage after the job is done. Other than that: when you hold the blower, the position of the hole of the exhaust should face down to you, so these two pieces, the small extension and the exhaust connected together then look like a reversed “U”. Got it? You need to hold the blower itself in one hand and with the other hand you need to hold tight the first extension piece, the one which is connected to the blower itself. If you have abilities kind of like a circus artist, the ones who can balance out and spin plates on an extension pole, you are definitely a winner. I pointed the hole of the exhaust piece approximately 2-4 inches away from the micro mesh of our gutters and then gave it a full blast. Man, even the tiniest pieces like shingles debris were blown away, amazing! Actually, my first attempts to work with this tool were not really successful, because the exhaust piece started to spin off the small extension piece and it fell off to the ground (lucky me that I did’n’t need to climb on the roof). It all depends on the angle direction on how you point the exhaust piece to the gutter itself and on the distance from the gutter. For me it worked out having the hole of the exhaust piece pointed almost directly on the surface of the micro mesh in a distance of approximately 2-4 inches from the micro mesh itself. The force of the air blown out of the hole is immense. Trust me, it is. It makes the entire construction shake and tremble. A humorous final note: When I started to start the cleaning process of the micro mesh on the front gutters, within minutes an audience of neighbors gathered in a safe distance from our property, looking in pure astonishment at me and asking themselves: what the hack is this guy doing there? Well, you need to know that in our Panhandle neighborhood there are people living who still think that the Firebird is the latest invention in the world of US cars and if you tell them about “EV”, they understand “ET”. Never mind. My final verdict on this gutter cleaning tool is absolutely positive. It works better than any of these gutter cleaning brushes I used before.

Great idea and an almost great product. It’s a little expensive, considering what it is; but very worthwhile. Makes cleaning gutters, much safer and easier than climbing up a ladder. Works exactly like it should One minor issue (in addition to price). - Because it is shipped in pieces and screws together with course, plastic, threads - the parts get loose and spin apart fairly often. It’s possible this could be fixed by assembling it with a pipe wrench…. And just cranking everything down super tight. Or, putting a material like calk in the threads before assembly. So, this is a minor, correctable, defect.

Absolutely amazing. It's light but sturdy, and screws on perfectly to the machine. I have used it at least 6 times already mostly because it works so well and is just plain fun. The ego blower shoots the leaves and debris (and water) out of the gutter at a great speed, so make sure you have the angle just right or you'll get a shower. It easily can blow the leaves 10-15 feet out of the gutter. All the neighborhood dad's are impressed. Get it.

This is a great unit. It fits my Dewalt blower perfectly.At full power it unscrews the elbow,so a small screw through the joint stops this.It's very rigid and does a good job.This beats the hell out of climbing ladders.Very happy with it.

The EGO Gutter Cleaning Kit is my leaf blower's superhero alter ego, revealing its uncanny ability to conquer gutters with the finesse of a ninja in a treehouse. It's like my yard work gained a jetpack and ascended to new levels of cleanliness. The compatibility with various EGO leaf blowers is the Avengers-level team-up I didn't know I needed. The transition from leaf-blowing to gutter-cleaning is seamless, like a superhero changing into costume at lightning speed. I half-expect my leaf blower to whisper, "I am Gutter-Buster" when I attach the kit. Now, let's talk about the 4 stars. The cleaning efficiency is stellar, but occasionally, I wish it came with a leaf-blower sidekick to handle the missed spots. The kit is a hero but not immune to the occasional villainous debris sneak attack. In conclusion, the EGO Gutter Cleaning Kit is a 4-star sidekick that turns my leaf blower into a gutter-cleaning superhero. If you're ready for your yard work to ascend to superhero heights and don't mind a bit of debris drama, this kit is your leaf-blowing guardian angel! 🍃🦸‍♂️🌟

Great for one story homes (Bungalows) but will make even 2 story homes easier with the use of a ladder if needed for height. Gutter cleaning is NOT my favourite task and using a ladder it would often take about 90 minutes. If you already own the EGO Blower, the blower attachment is a must. Now I complete the job in about 20 minutes. Highly recommended

Works great. Fits perfect