Throttle Accelerator Accessories Replacement Part Compatible for Xiaomi 1S M365 Pro Electric Scooter

Connection didn’t match it was 2 males but if your handy just cut the plug and crimp it together works really good

Fits many scooters, but the plug may vary. I soldered the original plug to the new part, works perfectly.

After two months it stopped working

I had an error E7 code with indicates a bad throttle. This part will work with VolPam scooters but you will need to use the connector for the old part and splice the wires together. On the old throttle, the wires are red, white and black. This replacement one has red, black and green. Just connect the spliced red to red, black to black and then the green to white and it will work. Make sure you cover the spliced wires with tape or wire wrap. It's a cheap and easy fix with a little know how. Good luck.

good part just not the correct plug in for my scooter a volpam had to do a bit of electrical work to fix it but overall good product

Easy installation and a great fit for what we needed to fix

Good quality, perfect fit, got the scooter working for not too expensive.

Bought this to replace a broken throttle for a nice scooter i got given too me due too them not figuring out how to fix or even remove the broken throttle! lol The throttle was easy to remove and replace. Only downside is that i believe the potentiometer inside the new throttle isn't good i usually only get about half throttle when fully pressing it but when i release and press it really fast a couple times it starts to show full throttle! honestly for the price cant really complain but if your wanting one that is going to work smoothly and perfect every time i don't recommend this at all! go for a better built one! I only really bought this for its cheap price and to see if the error code the scooter was showing was really the throttle! It did however after installing the code did disappear just not a consistent power output from the unit!

worked fine on gotrax ultra. Cut old connector that is compatible near the connector of the old throttle. Tie a light, strong string on the wire before pulling old throttle out. Remove uncompatible connector from new throttle cutting wires close to connector, tie end of wires to string and pull new throttle cable through consul. Place a small piece/diameter shrink tubing down wire away from solder connection, using rosin core electrical solder joining same color wires to old connector and shrink the tubing. Tighten new throttle in easy to use position and check for binding. Replace grip making sure that it doesn't bind with throttle. Put something over circuit board to protect from solder drips.

Quick delivery. Product as advertised. Works well with my Xiaome