Taidacent Hollow Slip Ring Signal Power Continued 2/4/6/12 Road Collector Ring Conductive Electric Motor Slip Ring Rotating Connector (2 Wire 1.5A Inner Hole 7mm Outer Diameter 22mm)

I fixed my budweiser clydesdale carousel lamp. Had to make some modifications to the budweiser clydesdale on parade lamp, but it work's great. The motor spins without any problems. The fluorescent lamp lights up without a flicker. The slip ring is constructed with quality parts. Well manufactured and constructed. I would buy from Shenzhen Taida Century Technology Co. Again

Works for me. My waterwheel is water powered and the lights are attached to the wheel.

Construction is high quality, wires and insulation are very good. Input and output (static and dynamic sides) wire colors even matched with 0.000 ohms of resistance, likely due to the gold contacts.

Nice but way smaller than I expected.

The build quality is horrible. The inner wires are installed such that they make the ID much less than 12.7mm. I'd have to grind this quite a bit to get a 12.7mm shaft to fit. As you can see in the photo, the inner hub isn't fitting properly with the blue mounting ring. I'm not even trying to connect it, just returning it.

Used this to make a little rotating radar display prop and it worked great! Was able to 3d print a large disc to spin with LEDs when attached to the outer ring while having a small motor shaft through the center to rotate it. The extra wires are convenient for powering more devices. Even after hours of constant usage at about 30RPM the ring still rotates freely while driven by a small 3V motor.

Great item! Fast shipping

These worked perfectly for continuing power to minion chairs.