Corsair Hydro X Series, XT, Hardline Bending Toolkit, (12mm &14mm)

I feel this kit is a bit highly priced for what it is, but you get a TON of convenience, everything is well put together and easy to use, and it's nice to have an area to store all my tools for looping.

Super convenient if you’re new to heat bending hard tubing. A lot of experienced water cooling builders have their own methods based on experience but if you’re starting off, the tools included really help you learn. My first bends came out amazing thanks to this set.

A bit pricy

The performance was amazing, it did its job and was very easy to use, the fit was Amazon and it had to be based on your tube size, no leakage at all, the fit was crazy, it’s worth the price!

OK

I want to start off by saying my rating is likely due to this being my first time setting up water cooling, working with bending pipe, and the frustration that comes with it. To start off, the cutting jig was made of plastic. I would assume it's primary purpose alongside holding the pipe is to ensure you're sawing straight. It was very easy to saw into/shave off the cutting jig's material without noticing. The tightening screws were sharp enough to leave marks on the hardline due to being metal. Next, the bending mandrel is also plastic, so it didn't seem optimal with using a heat gun anywhere near it. Whilst being careful heating the pipe, it had melted. It was also not useful if you planned to do more than one angle on the same pipe. I didn't have any issue with the saw or deburring tool, but at this point, half the bundled goods were useless. I would suggest spending just a little bit more for a bending kit made with more optimal materials.

This is the most overpriced piece of plastic junk I've ever bought. Corsair usually doesn't disappoint but I guess they're known for their PC parts, not tools. The saw is flimsy and horrible, and everything else is just as bad. It's all lightweight, cheap plastic. My bending tool actually ended up melting too and Corsair refuses to refund me. Do NOT buy.

It's not the fault of Corsair, it's just the nature of a hacksaw. You will want to sand the cut on a flat surface to get it even. I ended up buying a 12in miter saw in the long run.

Pour monter soit même son watercooling c'est le top 👌

Save $100 and buy $5 twistie tube cutters and a $5 silicone bending insert. Also not compatible with 16mm tubing

as described

La gente quemándose de que la herramienta para cortar lo hace chueco claramente nunca ha usado una segueta. Si se tiene experiencia con ese tipo de herramienta se sabe que se tiene que hacer una leve inclinación de la herramienta al cortar o sale mal el corte. Las personas diciendo que se queda atorado el tubo en la herramienta de doblez deberían dejar de calentar el tubo mientras está dentro de la herramienta. Para quienes dicen que el inserto se queda atorado, usen algún tipo de lubricante. El jabón Zote funciona bien.

Nice idea with poor execution in order to maximize profit. The bending tool isn't made of a high temp plastic and will basically melt along with target tube if you hit it with any heat. The rubber tubing they give you to prevent crushing and kinking is short, so you will have problems bending longer tubes with multiple bends. The little saw is fine for what you are cutting. The provided jig is also good / fine. The sanding / deburring tool works well. Basically 3 of 5 because of the first two points. I don't entirely regret buying it but mildly unimpressed also.