DEWALTRouter Edge Guide for Fixed Base Compact Router (DNP618) Medium

This is used with the 20 volt DeWalt router fixed base!It uses two screws to attach it to the base.When done using the guide you remove the screws from the guide/router base and then screw the two screws back into their original holes on the guide!Very simple and easy to keep track of the screws!Easy to adjust distance and keeps its setting while you rout! Highly recommended!

Works perfect!

I was looking for some V-groove tongue-and-groove pine with a V-groove on both sides. Since I couldn't find any locally, figured I'd get the single-sided V-groove boards and route my own V-groove on the backside, so purchased this edge guide to help with that. The guide installs very easily on either the corded or cordless trim router with two machine screws (included), and no need to remove the router's base plate. The edge guide, once set to the needed width, is held securely in place...I didn't notice any slop or wobble when sliding along the length of the 100" long boards. One thing I would recommend...attach a piece of scrap wood to the face of the guides...this would help prevent the guide from turning once the leading edge of the guide passes the end of the workpiece (small gap between the leading and trailing faces of the guide). I'd recommend using a piece of MDF since the faces are fairly slick and would slide easily along the workpiece.

I use this with my Dewalt DCW600 cordless router and it fits and works perfectly. It is easy to install and remove, and is made with high quality materials. I am very pleased with this edge guide.

Makes your DeWalt Palm Router into a straight line dado/groove cutting machine. It attaches with 2 screws to your DeWalt Palm Router and you are ready to go. I routed the top of my cross cutting sled for T-Tracks in about 5 minutes. Would have been quicker but I took multiple shallow passes.Yes, sawdust is a nightmare but so is not being able to rout straight clean dados. This is a basic accessory but it works so simply you will kick yourself for not buying it sooner.

Excelente

Tool worked great. Made job much easier with better results.Used this to removed cabinet door panels with my router and put plexiglass in its place.

Well designed and made tool that works well and is definitely worth the price. Since it's basically a required attachment, it's nice to see a reasonable price as they could get away with charging more.One con, the black on black ruler markings are hard to read, but it's not much of a con since I doubt many people use them; pretty much always better and more accurate to use a marking gauge or other tools to do the layout and then set the fence to those markings. If you have to repeat a setup, again much better to cut a block that registers the right distance between cutter and fence.One tip: buy some 3/4" UHMW tape and put it on the fence faces, being sure to wrap it around each end so the tape edge never grabs the work. For those who haven't used it, UHMW plastic is like solid teflon and will make the fence slide on the work much more easily. However that will also skew the integral fence ruler measurements by the thickness of the tape (~1/32"), so if you do use that ruler you need to take that into account.