CALPALMY (2 Pack) 1/8" Thick Clear Acrylic Sheets - 24" x 36" Pre-Cut Plexiglass Sheets for Craft Projects, Signs, Display Cases, Sneeze Guard and More - Cut with Engraver, Power Saw or Hand Tools

Quality, durable, and clear.Easy to cut,Thickness just right.

Nice quality, good price, packaged well

Daughter needed a "floor" for a wire mesh countertop basket for her spices & bottle opener. This material cuts to shape easily and is strong enough to avoid curl and flex once positioned in the basket.

I used these panels as my aquarium lid. They were easy to cut to size and are sturdy enough to hold two plant lights plus some. They only have any bend to them when a lot of pressure is applied. Unfortunately they do scratch very easily! I literally only have plant lights on them and only move them for tank maintenance and they are some how super scratch up It’s a little annoying but not too much since I’m usually viewing the tank from the front anyway but the light would be able to penetrate better if it wasn’t so scratched up

Comes with protective film and corner clips to protect the edges. The acrylic arrived unscratched and is very clear and beautiful. The sizing is accurate.

Came well packaged and just as ordered. I was a little annoying trying get the start of the film at the corner. Once that was started it zipped right off.

Sturdy and rigid. These panels are perfect for placing a large calendar in between and mounting on the wall with stand off hardware. I’m making large a dry erase calendar and I was concerned these panels were going to be flimsy and floppy but they are very strong and rigid. Perfect for my application. They’re thick, perfectly clear, easy to use and clean.

Bought this for use with a laser engraver. This simply isn't acrylic. It doesn't cut so much as awkwardly melt, leaving horrible bubbly raised edges, and requires far stronger power settings than 3mm acrylic should to even achieve those partial results. Also lacks the distinct smell of laser-cut acrylic, trending closer to, I think, lighter fluid, perhaps? Maybe it's ABS, or PVC, or even polycarbonate? Dunno! Doesn't matter! Can't laser it, so it's useless to me. If you're just cutting this with a saw or using it as-is as a plastic panel, it'll work fine, but again, and I cannot stress this enough This Is Not Acrylic, It Will Not Work In Your Laser (and always be sure you understand the risks related to any material you put in your laser) (This is an unknown material, and thus presents completely unknown risks) DO NOT LASER