SPARIN [2 Pack] Surface Go Screen Protector, [Tempered Glass] [High Responsive] [Scratch Resistant] Screen Protector for Microsoft Surface Go (10 Inch, 2018 Release)

This screen went on fast and was actually easier than the one I put on my cell phone which cost much more. The tabs are key. First, watch the youtube video. It shows putting 2 tabs on the short side, I used 3 tabs on the long side. The protector is very very slippery and I didn't have a helper to hold it in place while I attached the hinge tabs to the screen. So what I did (BEFORE removing film) was position it by using a small piece of scotch tape in the middle of each short end, applying the tape to the protector top first. You can then ease it in in place and make fine adjustments without worrying about messing up the provided hinge tabs. Press these scotch tape pieces to the edge of the Surface Go and double check alignment. Adjust if necessary until perfect. THEN put the 3 hinges on the long side. When these hinges are folded over and attached to the protector you can take off the scotch tape pieces and proceed to cleaning. Important: make sure there is no slack in the hinge when folding over onto the protector I have hot air heat in my house which blows around a lot of dust. I turned the thermostat down (or up if you have A/C) so the system wouldn't trigger and start blowing dust around in the middle of my installation. I also wiped down the surface I was working on, and washed and dried hands with a microfiber dish cloth. I used wet swab, then dry swab then tacky strip. I removed the film steadily and quickly trying not to stir up any air current. (don't let the sticky side touch anything after the film is off!) I closed the hinge and it immediately started adhering from the hing side across the screen until it was solidly on. Not one piece of dust or bubble, and perfect alignment! Love it!

Good thanks

Just like many of the other reviews said, I found it perfect, too. I had a bit of trouble getting out one bubble, but I think that's because my original screen already had a scratch in that spot. Other than that, the instruction video is very accessible on YouTube, and the accessories provided work perfectly. Glad to have better protection now, for my Surface Go screen

Comprato per il Microsoft Surface Go2 ed è perfetto, non arriva al bordo è meno di 1mm più piccolo dal bordo ma nessun problema anzi. L'applicazione è facile e veloce, nessuna bolla, appena lo applicate aderisce subito. Nella confezione trovate anche 2 salviettine con l'alcool perché sono due i vetri che vi arrivano, un panno per pulire, e le istruzioni, tutto ben custodito in una custodia rigida per conservare il secondo vetro, veramente ben fatto.

La mica es como todas, nada extra. Pero envían muchas cosas innecesarias que solo generan desperdicio. Todo viene en plástico, a este punto ya deberían saber que todos tenemos pañuelos, alcohol para limpiar pantallas, pegatinas para remover polvo, etc. Lo único entendible es el empaque en donde vienen las micas, pero lo demás es BASURA.