LED Underwater Pool Lights, 3W,12V-24V DC, IP68 Waterproof,Stainless Steel Aluminum,for In-Ground Swimming Pools Steps Ponds Fountains (Cool White-6000K)

It works fine but the cable length is ridiculous for an out door light especially near water

They work well but the back clips seem to rot quite quickly when underwater, I think the backs are aluminum as they get like aluminum rust basically a white dust... when this happens the steel clips break off.

Our Hayward $800 light went out again (gone through 2 haywards in 3 years)! I bought this based on reviews and gave it a try. This is an EXCELLENT replacement light - I spliced the wires into the existing Hayward 100 ft cord and it works perfectly! Super easy to install - I used waterproof heat shrink connectors and waterproof heat shrink sleeves to ensure the splice was completely sealed and water proof. Beautiful color and nice and bright at a great price.

I have a smaller Sunlite pool light that kept failing (it's about 3.5" in diameter and takes a small two-prong bulb). Upon opening it up, I discovered the water had completely corroded the bulb socket. Since this LED light is waterproof, I decided to convert my light over - I removed the four prongs inside the housing and the two on this light (to make room for this light), used waterproof connectors to connect the low voltage leads, filled the wired area at the base of the housing with silicone, inserted this light, added more silicone around it and foam to keep it centered, and reassembled the unit. With these adjustments, this light fits perfectly. The brightness is more than adequate and it works great. If it works months and years from now, then it's a home run ... but for now, so far so good.

I was fed up from replacing my colorlogic lights at $500 each every year. I took a chance on these lights given their price points knowing I’m getting slightly dimmer light and no color change - just blue. Installation is straightforward. I cut the wire and used waterproof connection. I used the cabling that came with colorlogic light. Note, these light works on AC 12v or DC 24. My transformer support AC 12V. Hence, no change was required at the panel. I can not comment on product life since I just installed them. But even if they fail every year, it’s still much cheaper than Hayward colorlogic 320 option. Note: top light in photo is Omnilogic. The bottom two ordered from Amazon.

The lights fit in the Globerite receptacle, pentair wanted $500 a light to replace, I reused the wires from the existing ones. spliced them with waterproof splices and covered with flexseal tape. I replaced the pentair color switcher with wifi smart switch and I can now turn my pool lights on from my phone, or on a nightly schedule. If your tired of shelling out thousands on pentair lights that only last a year, replace with these! Update: unfortunately these lights only lasted about 10 months and all three stopped working. It looks like they can't handle salt water very well as there was a lot of electrolysis build up on the housing and water inside the LED fixture. I'll probably just swap them out with another set given the low cost, but it's a bummer that they didn't last.

I replaced my Hayward colorlogic for this. Almost the same light output, although it can’t change color. Fits 1.5in tubes easily. As many mentionned, the cord is a little short, had to extend it to connect where I needed. Would definitely buy again!