WiFi Antenna Dual-Band 8dBi RP-SMA Male MHF4 Cable Kit for M.2 NGFF Card

I bought this to upgrade the Wi-Fi performance on my desktop using an Intel M.2 Wi-Fi card, and it works exactly as advertised. The 8dBi antenna provides a noticeable improvement in signal strength and stability on both 2.4GHz and 5GHz bands. Installation was straightforward, though you’ll need to open your case and carefully attach the U.FL (MHF4) connectors to your M.2 Wi-Fi card which are very tiny, so took my time. The included 10-inch extension cable is the perfect length to route to the rear I/O slot, and the bracket fits cleanly into a PCI slot for a tidy setup. If you’re using a desktop with an internal M.2 Wi-Fi card and want better signal strength, this kit is a great value. Just be careful when handling the small U.FL connectors during installation. Highly recommended for DIY PC builders or anyone upgrading a small form factor system!

Works exactly as expected. It isn't getting me the 400mbps speed that my phone gets off my router, but I'm fine with what I'm getting in 100-180mbps category.

I used this to allow me to change my desktop case. The old HP case I had came with a built in antenna into the case and wasn't removable without breaking things. The motherboard had a M.2 style WiFi card so this fit perfectly on that card and has given me fantastic signal since installing. I think it's even better signal than the built in antennas were because these are bigger too. Do be careful though, have patience with plugging the wires into the WiFi card as they're super tiny and difficult to line up but after a minute you'll be good to go. It's a one-and-done type job so I don't plan on having to reinstall this again so it wasn't a big deal.

Tried a slightly cheaper set of antenna that would not connect to the card due to problems with the wires. However these worked great, went on the card first try with very minimal effort. Didn't use the back plate, as motherboard already had locations for the antenna to hardware, but it was easy to remove the backplate and attach to motherboard spots instead. Overall good value for the money, defintely watch which brand you get as the antenna wires can make the installation miserable. This ones worked 100% without any issues though, defintely would recommend these.

Bluetooth y wifi rápidos

From the standpoint of functionality, this works well. The signal for Wi-Fi and Bluetooth is strong. The external antennas seem to be well made. However, the slot bracket feels kind of flimsy and moves and flexes when you’re adjusting the antenna. Luckily, it’s not something I’ll need to adjust often. Also, the wires that attach from the card to the antennas isn’t very long. Due to the position of the m.2 key E port on my motherboard, I had to route these wires over the GPU, which isn’t ideal.

new antenna leads on modern wireless cards are a pain to snap on the first time, after that tho once they are fully seated work great... there really isn't much to review here you just need to know what you are buying this is a niche use case

Connected the antenna to my new Intel Wireless-AC 9560 that I bought to replace my PCIe Wireless and bluetooth combo card which only gave me a 60% WiFi signal and kept having interference problems with bluetooth devices. Only had a very minor shipping issue that very slightly bent one of the wire connectors that plugged into my card which was corrected by just gently rocking it back and forth on the connector on the card until it snapped into place. Despite high power interference surrounding the antenna, I receive a 100% WiFi signal to my home network that's located clear at the other end of my house and I get a 100% bluetooth signal through out the back half of my house where my computer is.

Seems to pick up signal fine. Doesn't come with bracket screw which was an inconvenience.

Reception succesfully increased. Would recommend.

Antennas come loose with the slightest bit of force and the cables aren't even long enough to travel a straight line from my PCIe bracket to my M.2 WiFi card across my motherboard. I don't know how people got use out of this E-waste but I spent a good 10 minutes trying to fit the tiny pins onto my card but but the wires didn't have enough slack.

Funcionan bien detectan la señal a unos diez metros de distancia, no se si más pues no he tenido la necesidad de colocar el cpu a mayor distancia. La foto muestra las antenas en la parte baja de la misma.