TP-Link AX1800 WiFi 6 Extender Internet Booster, Covers up to 1500 sq.ft and 30 Devices, Dual Band Wireless Signal Booster Repeater, Gigabit Ethernet Port, AP Mode, OneMesh Compatible(RE600X)

I am well versed with Wifi technologies. This is a great little extender that I used in an home ASUS mesh environment. While this does not connect to AImesh it does connect easily to the environment and is compatible. I use this for a covered patio outside during the warm months of the year. I access the GUI through a web browser interface....not an app so I can't speak to that (just old). It is a dual band extender. I usually use 5ghz for the backhaul and 2.4 for the extension channel. At max performance this device easily reaches my shed with strong signal about 100 ft away. I choose a more limited performance due to wifi interference at the 2.4 level. This works extremely well on covering the patio areas and not bleeding over into the house. This device replaces much more expensive devices (Nighthawk extenders) and works far better. At the $40 deal price that I purchased this on it can be offered up outside under the patio and is affordable to replace unlike the Nighthawks. I've had problems with the GUI in the past with TP Link but this web interface was straightforward and easy to follow. Its easy to plug it in and then unplug it when necessary. The boot time is long but that is the case with most network devices. The connections are solid to multiple devices and the throughput and download speeds are acceptable for 4k streaming from the internet and internal network. A worthy purchase at the price point for my use.

We have struggled with a weak wifi signal at the rear of our home for several years. I have tried the XPods and another extender type device with no luck. Lagging streaming television and weak wifi on cell phones at the further most point from our router were a constant issue until I purchased this device. My intention was to try the TP-Link AC 1900 as a wireless extender first to see if I could get the signal to improve. Setup was fairly easy after I downloaded the app and followed the guidance. This device feels well constructed and booted up quickly. Once I got it up and running, I checked the download speeds in the dead spots of my home and it did boost them... not significantly but a noticeable boost. Basically, from 1-2 Mbps to 12-15Mbps. I then decided to use the AC1900 as an access point due to the fact that it has an ethernet port. Once I figured out how to change the settings to access point, I plugged it in to a hard line that I had run prior at the rear of the house and then checked the speeds again. To my delight, the speeds were now in the 300-400 Mbps range repeatedly. This was a huge win for us as we have struggled with low internet speeds in portions of our home for years. Setup was a little confusing as I had to figure out how to name the network and set passwords so that we could access it. After reading some additional info and watching a few youtube videos, I was able to get it all up and running. The nice part was that I was able to name the new network the same as our existing network with the suffix ext to identify that it is the extended network. Same password and for the most part, our phones would recognize the stronger signal and switch almost automatically. Our streaming TV's and my son's headset gaming system are now booming with wifi thanks to the TP-Link Extender. I believe this is a real upgrade and solution to low wifi signals in the home. Well worth the modest investment for the increased speed and reliability of you home network.

Usually wont write reviews unless the product is actually worth taking the time to do so for. This product is no exception; the extender works amazingly! Took spotty, low reception Wi-Fi getting essentially dial-up levels of MBPs to only 150 MBPs less than what I get on the non extended wifi near the router. Typically they say that these extenders will only get at max half of the original wifis bandwidth speed however thats not an issue with this unit. I used a wifi strength tester to find the best spot to place it between the main router and the camper outside the indicator also let's you know if its too far when you plug it in. Overall amazing product - well worth the price. Would recommend to anyone who is experiencing spotty, low-speed connection, to use the easy to set up, functionally amazing, well priced range extender!

After dealing with stubborn Wi-Fi dead zones in the upstairs bedrooms and on the patio, I picked up the TP-Link RE550 — and I’m happy to report it delivered a noticeable upgrade. Streaming is smoother, smart home devices stop dropping offline, and pages load without that frustrating “spinning wheel” delay. Once connected, performance has been stable and speeds remain impressively close to my main network. I especially like the signal strength indicator LEDs on the unit — super handy for finding the ideal placement. The Gigabit Ethernet port is also a great bonus for devices that benefit from a hard-wired connection like a TV or gaming console. And being EasyMesh compatible gives me room to expand in the future, which is a nice plus. Where it fell just short of 5 stars: • The setup wasn’t as smooth as advertised — the app froze once and I had to reset and retry pairing • It’s a bit bulky, so depending on your outlet placement, it may be a tight fit Once everything was sorted, though, it’s been rock-solid. Great range, strong speeds, and no more Wi-Fi “dead zone frustration.” A solid upgrade for anyone wanting to extend reliable coverage without jumping fully into a mesh system just yet. 🦊📡 Fox Den Reviews Approved — Reliable Performance With Minor Quirks

Its works great. I installed it in an in-law suite the is a separate structure from the main house. Before the wifi signal was very weak. Now its as if the gateway was in the building, full signal. Very easy to install.

I am writing this after about 2 weeks in use. I bought this extender as a replacement for a Linksys (RE7000) extender. This is paired with a Linksys WRT3200ACM Router. I was having fits trying to keep the RE7000 paired as I only had it on the second floor going thru 2 interior walls less than 50 feet straight line from the router. Knowing the popularity of mesh systems driving the price of extenders down, I decided to look around at them as a low-cost replacement with higher reliability than my older Linksys RE7000. The setup was very simple, as with most extenders, you plug it in close to your router and hit the WPS button to sync it. If you want to customize the SSID name(s), you can use with the phone app (Tether) or use the direct IP address via your browser, which is probably in the 192.168.1.xxx range. There are a few more options going thru the web configuration than the phone app, but I am very pleased so far. I do feel like the 3 antennas on the unit are very beneficial, as when I would take a power hit, the Linksys would take forever to reconnect with my garage door and ring camera. As a test, I simply unplugged this RE550 and plugged it back in - both 2.4gz devices connected right away after the RE550 connected to my router. And I've had NO disconnects with the companion phone apps (Ring for the camera, myQ for the garage, PLEX on my Roku, nor DirecTV). With 1gz Internet service in a 3200sf house, this extender does the trick. Someday I might go to a mesh system, but right now, the extender SSIDs are giving me 4-5 bars of signal strength throughout the back-half of the house where the main router covers the front half. Streaming on my ROKU/Plex has been perfect since migrating to this TP Link RE550.

The GOOD: once up and running, it delivers excellent range extension, and the 1Gbps ethernet connector works well - am getting close the maximum my fiber network can provide. The BAD: the configuration options are awful. Initially I tried the Tether app option, but it would not register the device. Maybe that's because my router is an Eero, not a TP Link router; but in any case I tried repeatedly and it would not get past the first screen. The support video for the device install actually depicts different setup options in the app, and shows a different model of extender - so not really helpful! I was able to configure the device fairly easily using an Ethernet cable to a laptop that was not otherwise connected to the network. BUT... after configuration, I wanted to go back and make changes, and I could not get back in to the administration screens - again, I tried the Tether app, and the suggested tplinkrepeater.net link - neither worked. The only option was to factory reset the device and start over again. The UNEXPECTED: I could use this device to heat my office! Boy, does this thing run HOT. According to my laser thermometer, it's at 119 degrees F !! I have to say I don't care for the design either. It is big, and is intended to be plugged directly into a wall socket. I put it on a 12" extension so that the back of the unit could cool, away from the wall.

I have a small business and need WiFi to run the computer and an encrypted credit card terminal at the front desk. My router (Verizon) is bolted to a wall in the back. I was getting really frustrated with the drop off. TP-Link to the rescue! Syncing it up was a breeze. Now I have flawless WiFi in my office. It's a fantastic product. Highly recommended!