Replacement B-0044-H Pre-Rinse Hose for T&S Brass, 44 Inches Flexible Stainless Steel Hose with Heat Resistant Handle

I run a busy diner kitchen. We go through pre‑rinse hoses like crazy. The T&S original ones? They last maybe 8–10 months before the braiding starts fraying or the fittings leak. And they're expensive to replace. Bought this as a replacement for our T&S pre‑rinse faucet. Was a little skeptical because it’s not the name brand. But man, it’s been over a year now and it still looks and works like new. The ends are solid brass – no drips at the swivel joints. The rubber liner actually holds up to our hot water. And most importantly – no kinking. You know how cheap hoses twist up and block the flow? This one stays straight. Install took 2 minutes. Threads matched perfectly. Same length as our old T&S. Zero issues.

Less than two months in use. Leaks started in the hinges of the hose. Had to throw out and replace.

I own a small BBQ joint. The T&S factory hoses we used to buy would kink constantly. You'd have to stop and shake it out to get water flowing again. Drove me nuts. Been using it for 14 months now. No kinking. No soft spots. The outer looks a little dirty but no fraying.

First thing I noticed – it's way more flexible. I can move the spray head around without the hose fighting back. Water pressure is strong with no weird restriction. And no more drips.

failed in less than a week. The one before that failed in less than a month. It is odd because I have bought this same one from the same seller and did not have any issues before. I will not be buying this again from here.

The old hoses would last us maybe 2‑3 months before they started leaking at the crimps and not seal to faucet. I bought this as an experiment last January. It's now been over a year and a half. No leaks. No cracks. The fittings are still tight. I honestly forgot it wasn't a T&S until a buddy asked me what brand I was running. The only difference I can see is the price tag. I paid less than half of what T&S charges.

Replaced our busted T&S hose last month with this B-0044-H after burning through 2 generic hoses this year. Night and day difference! The stainless steel braiding is WAY thicker than our old one. No more warping or hot spots near the spray head during heavy service. Fits our T&S Brass pre-rinse faucet like it was OEM – zero leaks with the stock washers. Held up to grease, boiling water, and our clumsy dish crew. 44" length gives perfect reach over deep sinks. Saved us $80 vs. the T&S brand part. If your kitchen runs hot and heavy, stop wasting money – grab this hose.

I have had this product for 2 weeks and it's already leaking. Not sure what to do, but it's a problem.

Not the real T&S hose, just a cheap replacement, used for my customer and leaks from ends. wastage of money.

I don't even know where to start. They state that it fits TNS brass but TNS brass uses half inch not three quarter inch. I then went down to Home Depot to see if I could make this work and use some sort of adapter. The description says that these are three quarter inch but nothing at Home Depot fit. They told me I would have to go to a specialty plumbing store to get a special adapter. Waste of time and money. Technically my fault for not being thorough enough to read through the description but should not be labeled fits t&s brass. Returning it getting my money back gave three stars just to be nice will never purchase from them again

horrible garbage product wasting money

The internal hose eventually leaks.