Flexzilla Pro Air Hose Reusable Fitting with Swivel, 1/2 in. - RP900500S

Worked well to repair my shop air hose. Stays put and has a nice strain relief that does what it's supposed to

Works as intended

I bought several, I've only used two, but they're very easy to install and super affordable. I used to pay quite a lot for those adapters until I found these.

So far so good, haven't used much but aren't leaking air and were easy to use and install. Feel a little flimsy, may not last for long or handle heavy use but seem great for the price and occasional use

Used the 3/8" reusable fitting with swivel to replace a leaking one on my manual hose reel. Other reviews say it may only work for Flexzilla hoses, but worked out fine for me. O.D. of my 3/8" air hose was 0.62. Took a little pushing, but it fit just fine. Didn't even need heat or lube, just elbow grease. I like the "no kink" spring which snap locks onto the fitting after it's all connected. Just remember to put the "spring" on (and the tightening nut) BEFORE you put the air hose over the barb! 130 psi, no leaks. Swivel is smooth and allows me to rotate the reel without kinking the hose. Good product.

Durability is horrible definitely not for every day use. I added this to my tint keg hose and they last about 2 weeks of every day use before falling apart. I ordered 2 and have been through both in a month!

Worked perfectly. I had a 100' hose that was handy when I bought it for a remodel project, but now was too long to be usefull, so I cut it down to a 25' and a 75' and it looks like they came from the factory and have zero leaks.

I now have 9 of these, 7 in use, and 2 spares for future expansion (the 1/2 swivel). They’re really excellent. The best feature is they have the same size orifice inside as a non-swivel. This is an important distinction as most ends that have a swivel will neck down inside more. It’s so important to me I bought a 100’ Flexzilla hose that for some reason necks down on the swivel side (you’d think it wouldn’t since they don’t with their replacement end) and I chopped that end off right out of the box and installed one of these. They take a minute or less to install, have never leaked, and most importantly never failed. Pro Tip: Don’t slide and snap the plastic coil thing on to the nut before you’re ready to tighten the nut onto the hose. It’s almost impossible to get off. Pro Tip 2: It’s easier to tighten everything up if you install an end into a vice. Using two wrenches is a pain, but certainly doable.

Worked great

This product is great, easy to install, doesn’t leak like my other crimp fitting on my air line. Nice quality product.

Bought 4 of them. The balls for the swivel didn’t last a week. These have to be the worst fitting I ever bought.Only one star because I can’t give it a minus 5 star.

easy to install on any .25" hose

Conforme aux attentes.