MAS Ignition Distributor W/Cap & Rotor Compatible with Nissan Pathfinder Frontier Quest Xterra Infiniti QX4 Mercury Villager 3.3L V6 Replacement for 22100-1W601

Perfect just what I needed and saved me 350 bucks! Would by from again. I waited till I drove awhile to give honest review. I definetly would recommend. Great quality, great double walled box it came in along with moisture barrier of poly extra large envelope, and careful stickers! Great Fit: Its the same size as what I needed Functionality: I read the reviews although there were some bad, this worked great for me, just make sure you know what model you need. Quality: Great quality Ease of installation: I had it done at the shop, it did not take long at all. I always ask if I can get the part myself, as they get from high priced napa. This saved me 350.00 for the part alone, and he said just as good as the high price store. Why did you pick this product vs others?: I got the number from the garage of what I needed so I can order myself to save money.

Fit my 2001 Nissan xterra as was advertised. So far works fine and fixed the mutiple misfire issue at idle and at higher rpms.

Pulled old distributor and set this one in EXACTLY set timing to top dead center. Engine did not want to fire off at all. Thought I may have put it in 180° out. So I pulled it and placed it back in @ 180. Still didn't start. Put Engine back to TDC. And repositioned the distributor back to TDC #1. No luck still. Pulled it back out after putting Engine back to TDC #1. Took all the guts out of this distributor and put them in my old housing. Put it back in and low and behold Engine fired right up. My conclusion is the drive gear is indexed wrong.

Best price, fix the camshaft position sensor

So I replaced the distributor on Monday, drove to and from the gym. Tuesday morning I left for work and about 3 blocks away my car misfires and then just dies in the middle of the street. After 4.5 hours of headache I got pissed off enough to tear apart this part only to quickly find out this little set screw was missing. I pulled the distributor out and turned it over when the screw and lock washer fell out. This means FROM THE FACTORY that screw was not properly tightened down. Got everything put back together and after $23 in parts, $45 in tools, and 4.5 hours of time I could have been working taken from me, car turned right over.

I ordered this distributor to replace a failing one in my vehicle, and it has worked flawlessly so far. Right out of the box, it looked well-built — clean casting, solid connectors, and a tight-fitting cap and rotor. Installation was straightforward and matched OEM specs perfectly. Once installed, the car fired right up and immediately ran smoother than it had in weeks. Idle stabilized, throttle response improved, and there haven’t been any misfires or hesitation since. It also came pre-assembled, which saved time during install. Timing adjustment was minimal, and the unit synced well with the existing ignition system and ECU.

Good

Fit my 2003 3.3 6cyl Nissan Xterra perfectly. After trying MAF, fuel pump, IAC, and testing vacuum hoses this did the trick. Just make sure to mark the exact direction the dial is pointed and that it matches when you install the new one. After it's in you can drive it away, but make sure to adjust the timing with a timing light ASAP. (Get engine to normal operating temp, turn off all electrical inside car and mare sure nothing is plugged into the 12 sockets, rev engine to 3k rpms, then turn off the car, unplug the BOTTOM harness on the TPS only, start car, rev to 3k rpms, with timing light on 1st cyl spark wire : time to the center of the pulley with timing light and then tighten the bolt on the distributor, turn off engine, connect the bottom harness on the TPS and start car. You're done! Not sure how long this will last, until I repair my factory one this is doing a great job so far :)

يعمل بشكل جيد على باثفندر موديل 2000

Hace 1 año mi camioneta Villager 2001 se Descompuso de algo de lo cual desconocía, gaste bastante dinero para tratar de arreglar y comprando piezas, finalmente me dijeron que era el distribuidor y pues compré uno por las inmediaciones de dónde vivo y fue una compra infructuosa ya que no era compatible, hasta que encontré esta publicación de Auto partes que menciona al rubro y decidí arriesgarme y no me arrepiento de nada, cumple con la descripción y con todo lo que dice, mi camioneta funciono luego luego y calidad muy buena, sin duda recomiendo este producto para personas que tengan el mismo problema.

Que es una pieza de reemplazo que se acopla perfectamente y que trabaja muy bien

El producto llegó a tiempo y forma

Quedé sorprendido con su funcionalidad se instaló sin complicaciones y quedó a la primera sin ningún inconveniente la verdad me sorprendió mejor que una parte usada .