J-B Weld 8276 Kwikweld Twin Tube Quick Setting Steel Reinforced 2 Part Epoxy adhesive for Repair, Dark Grey, Two 1 oz tubes

Excellent glue Works well on my broken Abigail Ahern pelican lamp that had broken in transit Super easy and sets quickly make sure to hold the men’s with light masking type tape until it’s set enough to take tape off Break has held strong. Be aware it is black and I really needed grey but I didn’t notice this when purchasing so I’ll just have to paint over the join

Love this stuff, had to repair a coffee mixing cup with a long handle, and the spot welds had broken. Tried araldite but didn’t hold. So tried this stuff and it held, and has held ever since. Almost invisible to the eye, but and it’s an important note, make sure you mix exactly the same hardener and the other epoxy. I made the mistake of adding a bit extra hardener hoping to speed the repair, it didnt help, as it never cured properly so had to do it again, with exact amount and hey presto it worked. Really strong as well.

I used it to fill a hole that I could not weld because of a fire risk did the job spot on .

One of the 3 tabs on the Aircon hose connector arrived completely broken off, I repaired the broken tab with JB Weld an automotive repair paste that can stand high heat and cold. Excellent product.

Just to start off this product is not or will never be a 'weld". This is a bonding adhesive that when used/mixed correctly gives you an extremely strong repair and one of the best I've used so far and I've tried a lot. The key point is preparation and if possible sanding and cleaning the bit you want to repair or connect with alcohol or similar cleaning agent/degreaser will be of benefit. I was after something that would connect a fastening pin to a military badge that had snapped off at the join. I knew glue would be pretty useless on a point that would be taking stress so decided on jb weld. I decreased with alcohol and then lightly sanded with a nail file as the pin and badge were so small. I only needed less than a thimble full amount but after I applied it and left it for half an hour..I cant budge it and it's probably better than factory. Since I've discovered this I'm now looking for things to fix which have included, A metal plaque, stone ornament and a heel on my wife's shoe....love the stuff! I've loads left as the tubes are equivalent to 2 x tubes of toothpaste. Hope this helps..

Easy to mix and use. Tried to fix a leaking pressure washer with a split in plastic pump body. It worked for that but unfortunately there was another leak that was not accessible so had to scrap it, not this product's fault though. Also used to successfully strengthen a repair to a plastic vacuum cleaner casing. I can see many uses for it and will always keep some handy.

Didn't work on cast iron works on light bits like soldering personally I think if you use it on stuff that does not need moving it would be ok

Excellent product. Works well for awkward repairs involving wood and metal. Even though this is the quick setting variant it's still worth leaving undisturbed overnight.

Ok

Very Nice Product and seller too

Fast delivery, Product says it contains steel in the glu. I can vouch for that, as I used this to glu magnets together and the excess wouldn’t wipe off after sanding, it just kept moving around. The steel powder leftover is some form of steel. Seems to be very strong, but not tested long enough.

Tiene una adherencia espectacular, y se mantiene firme con el paso del tiempo.

完璧な接着剤です