Pyle Phono Turntable Preamp - Mini Electronic Audio Stereo Phonograph Preamplifier with RCA Input, RCA Output & Low Noise Operation Powered by 12 Volt DC Adapter (PP444), Gray

Pleased with this product as it did what I brought it for. After buying a new hi-fi system, my record deck did not give any sound output. I needed a pre-amp to supply the amplifier and this item did the job excellently.

Great item

It would have got 5 stars if it had an on/off switch, but at this price I maybe being unreasonable Works well, but I still need to use a lot of top-end volume on the amp.

Spot on for the job

It works fine

Really good preamp with grounding point meaning no buzz. Works fantastically to connect my turntable to powered speakers. Excellent for the price

Very good preamp, came with a USA 2 flat pin plug, so had to buy a adapter, works great.

I bought this device on July 14 2014. It has worked flawlessly ever since to boost my vintage 1981 Technics turntable signal to a modern receiver with no preamp on board. Excellent sound and no interference noise at all. My vinyl collection is played regularly thanks to this little preamp.

Chegou antes do prazo e funcionando perfeitamente,muito bom pré-amplificador .

Read in entirety: I purchased a Technic turntable, old-school, have a complete zone home ent. system, using sonos as well as wired speakers with the HTD control module and amp. I hooked up this system myself, I am very tech savvy, takes alot to stump me... Now that that's out of the way. The turntable I purchased used is a mid to high grade Technic, came with a Pyle preamp that had no ground, turntable did not come with ground wire either, this is important, noted later. I initially connected the turntable to the preamp "in" that I had, not this new one, with no ground, then connected the preamp "out" to my receiver "in", then receiver "out" to my controller "in", no sound and loud annoying hum. I then tried to connect the preamp "out" to my sonos connect "line in" bypassing the receiver, same results, then tried connecting directly to my controller, same results. Researched, completely baffled, did I lose my techi touch? Scratching head, discouraged, defeated? Not on your life! I ordered a factory ground wire for my turntable and this preamp with the ground connection, then... I started all over again preforming the same connections as before but with the turntable ground wire connected, initial loud hum happened, then went away and had dead silence. Scratching head again. NOTE TO THOSE CONNECTING TO RECEIVER OR OTHER THAN AN IN WALL HOME SYSTEM... the most important thing to know, if you connect this preamp and put it too close to an amplifier or other high electric output it will still hum, this needs to be seperated a little bit, keep reading. My final setup is removing my receiver altogether, turntable to "in" on preamp, preamp "out" to sonos connect "in", sonos is connected to controller, ground wire connected to turntable and preamp. Placed preamp next to turntable on shelf above controller and amplifier, only about 6 to 8 inches apart but shelf appears to add a buffer. Everything on, no hum, but no sound. Tilting head questioning again, more googling. For my system, my controller controls the volume up and down not the music source, I had to put the sonos sound level for the line in to 10, auto delay to medium, autoplay on to include grouped rooms but turned off autoplay volume, this makes it so music will start once the needle hits the vinyl, line out level is pass through because I have a controller, and wala, sound. Now it will play on my sonos without me using my HTD controller but it won't hit my wired speakers in group until I turn that on but when I do it all works. IMPORTANT GROUND WIRE and PREAMP NOTE... If you have a turntable that has a built in preamp you should not need this, read up on your system as some newer ones have one built in and it's a matter of flipping a switch on the turntable. If you have an old school turntable you are trying to connect to newer technology you most likely will need this AND the ground wire, the ground wire helps to disperse the bad waves to a non audible source and keeps the good sound going where it should, to simplify the why, if you do not ground your turntable you could still have a hum. Some turntables have a ground screw or plug in connection located where the red and white are plugged in, some ground points are on the under bottom of the turntable, I've seen some where you have to open the turntable to get to it, research your turntable if it has a ground point, if it does anywhere and you still have a hum, connect a ground and place the preamp away from high electric output sources. Enjoy your tunes. Good luck!

Es de los bara y si son de buscar la calidad maxima mejor deberian comprar uno más profesional pero este hace el jale bien, eso si no hay boton para apagarlo asi que es conectarlo cada que quieres usarlo lo que resulta algo raro

Very fair price for the value of being able to hear vinyl on your turntable. I thought this Pyle PP444 had died on me after a month of use, but actually, I had forgotten that I just had to turn up the volume on the receiver. Need to turn down the receiver volume when using other devices like the TV. It works great...so uplifting to hear my old albums, thanks to this device that is so simple to use. The videos stink that are out there, and I can't believe that whoever owns Pyle lets the link from their website show the most ridiculous video as their sole video. I do not know what the little knob is for, however, and no instructions come with the device.