Evan Fischer Engine Splash Shield Compatible with 2011-2020 Toyota Sienna - TO1228174

Just adding this review because of the longer times noted in other reviews. With a smaller drill + 10mm socket I was able to change out the old and put in the new splash guard in ~15 minutes alone (no jack needed, you can reach everything).. the 10mm fasteners also had Phillips head. Fit was fine. Could take 30 minutes perhaps if using a screwdriver by hand.

I had used tape to keep my old one in place. Finally found this online and it is fixed.

This was not an exact fit for a 2015 Toyota Sienna. It required extra holes to be drilled in the plastic to align with the holes in the car.

it was fit but low quality, hand made holes and very flimsy and hanging beside that all screws in plac.not recommended at all.

After the old engine splash shied was destroyed due to the van's low repeated combo of ground clearance and steep driveway, I needed an inexpensive replacement. It took about an hour to remove the old guard and install the new one with help of another person. The hardest part was finding new trim clips that fit that was ripped off the old one. I did have to "adjust" a few holes to line up with the car frame, but much cheaper than OEM or paying someone else to install one. Van looks like like new now!

While I wish I'd quit destroying these things, this is a perfect replacement for my 2015 Toyota Sienna.

I ordered this an I was a little worried based on the reviews, but it fit great and seems just as good as the original.

I'm sure the OEM guard from Toyota would've been easier to install, but this one wasn't terrible. I did NOT have to modify it, but it did take some convincing to get the holes to line up. It does feel more flimsy than the original, but I'm not so sure that's a bad thing. It also does smell pretty bad fresh out of the box, but the smell quickly dissipated. I would recommend parking the car outside for a night or two so your garage doesn't get stinky. I did buy aftermarket plastic clips from Amazon that were a big help and I reused the original bolts along the bumper. All in all, it took me under 30 minutes to install with the help of my 5 year old. It helped that the original was already torn off.