100pcs - 10mm Nylon Clips Plastic Push Type Rivet Retainer Fastener Bumper Pin Fender Flare fit Honda Acura

Perfect fit for my 2013 Honda Civic! Had to replace undercarriage .

My Wife's 22 CRV fender liner was torn off when she had a 'cone intervention'. Easily fixable, but Honda uses two different sized push clips (and a few other connectors) on the 22 CRV fender line. I had the smaller ones but did not have this larger variant. A whole bag of 100 was cheaper than 4 of these from Honda and they appear to be good quality with no issues on the road so far.

Good quality. Snap in and hold tight.

great auto use

I have a 2015 HONDA ACCORD V6 COUPE. 100k mi. I damaged my fender well liner over time.. When I replaced it. The old clips never worked well again. They worked their way loose and I damaged the liner again. The fender liner connects to the underside splash guards and bumper cover. All 3 of these body liners/guards connect to each other and to the frame. They must be done right or the whole system fails. This time I got the 3 different types of fasteners needed and fastened things down right. With these clips and the other 2 types needed, your Honda will be buttoned down tight! This item is the 10 mm clips that go in every hole UNDERNEATH the car. Probably a dozen holes. Fill every one! one missing clip places undo stress on the others and the bottom will sag, rattles bad, and will not hold long term. With 100 you have plenty to fill them all. I even replaced the original brittle clips and these snap in much tighter. For inside the fender well you use a bunch of 8mm push pins (6 - 8 per side?). Finally against the firewall side, you use square push rivets (3 per side). Both available on Amazon: 1. 8mm - for inside fender liner - GOOACC Nylon Bumper Fastener Rivet Clip 8mm 90682-SEA-003 – Square Push Clips – No Center push post 2. Rexka 40pcs Fender Apron Liner Mud Guard Retainer Clip Grommet Retainer 90682-SEA-003 Now the car is like new again as far as the front end appearance and fitment. Very satisfying as you see so many cars on the road with flapping liners or underside sag. This is an easy fix with the right parts.

Purchased to replace some old and missing clips on my Land Rover Discovery 2. These do the trick, but if there was an option for 20, 40, or even 50 clips I would have opted for less.

PROS: o Inexpensive o Came "unassembled" CONS: o none so far Worked fine on the bumper cover of our 2004 Subaru Outack. Not having the center part of the rivet installed into the outer part of the rivet made the installation super easy, then just snapped in the center part and job was done. Haven't tried to remove them since I have no reason to, but I can't imagine that they would come out with much difficulty.

These definitely did job replaceing some of the clips on my 2015 honda fit that have been falling off. Cheap, abundant and good for any replacement later on.

Inner fenders

Bought these for use on my Honda CRV's MY04. Have used about 50 of them so far, awesome, cheap, work