3M Black Stripper Pad 7200, 17 in, 5/Case

3M makes a 14"x32" sized pad of the 7200 series just for the Clarke Boost 32" and other similar autoscrubbers (14x32). I will write a follow up review of this pad when it will be used. [edit] Used the pad last night to strip out a portion of hallway. Pad performed well and best of all, no old floor finish loaded up on the business side of the pad! I used this pad with conjunction of a Clarke Boost autoscrubber and the action of the machine (picture an over sized orbital sander) kept the bottom side of the pad clean throughout the stripping session. I have had experience with the 3M SPP pad (also sold here at Amazon) as well which according to Clarke should strip off all old floor finish (no it doesn't but it gets close!). The SPP pad is an excellent top scrub pad but it doesn't remove all floor finish. So here is how I use the 7200 pad w/ the Clarke scrubber: 1. Mix your stripper solution as per the instructions. If it's less than 6 coats of floor finish, then you can dilute it some. Mop on the stripper liberally and let it dwell at a minimum of 10 minutes. 2. Place the 7200 pad on the machine. Lower the pad mechanism. Turn your water level to just barely above minimum. Go slow! 1st pass, strip with the squeegee UP. 3. Make another pass after completing the 1st pass this time with the squeegee DOWN, vacuum on and the water level turned up from 1/3rd to 1/2 of full. The higher water level will flush out the pad. I did this and there was no old floor finish residue on the bottom of the pad. Floor stripped out fine! With this pad + an orbital autoscrubber (e.g. the Clarke Boost / Tomcat Edge Magnum)+ properly mixed stripping solution = a stripped floor!

I've bought this several times. I used it with my orbital buffer to strip saltillo tile that a previous homeowner had tiled and carpeted over.

Very good support team great product

shipping was very very very very bad availability very bad

Excelente lo voy a comprar de nuevo muy útiles