X-Ki Waterproof Grid Oval Round Bulkhead Ceiling LED Light,3-Color LED Light Source,Outdoor Wall Light,8.3 Inches,Suitable for Bedroom/Sauna Room/Storehouse/Wet Location,(Antique Copper Design) Brown

This doesn’t come with any sort of mounting hardware or instructions. I screwed the plastic housing directly into the wood ceiling after attaching the three wires with wire nuts. So far it has lasted through temperatures above 200 degrees Fahrenheit without any issues. This is bright and works well. First one arrived broken but they replaced it and this one has been great.

super cheap construction. Extra thin wire is about an inch long and no wire nuts for this extremely tiny wire. also didnt work

Very reasonably priced, these light fixtures work very well in my garage, they were exact replacement for my older light fixtures, they give a lot of light at a very low amperage draw, the weather proof seal around the glass portion made for a tight seal and I also caulked around the base to protect against humidity(It is better than that plastic crap the builder installed). Will continue to buy.

This is the second time I've purchased this same light. This light is quality and is extremely bright. You will be extremely happy with this purchase. This is a definite recommend for purchasing.

After all is done, they look great and won't rust. However my complaints are:1) The wiring is super thin. It was hard to strip the wires as it was some super high guage (thin). I worry that if these wires take on rust/corrosion of any kind you will lose the current you need to make these work. I get frustrated with manufacturers that skimp on small things like this to literally save a penny.2) It is not clear how the install on this was designed to work and there are no instructions. I have installed dozens and dozens of different lights and this one had me perplexed. It was not designed to mount to an electrical box because it is so light and small... However the depth of the unit itself behind the main light is about 1/4" so you cannot stuff wires behind it. You need a large hole into the wall that is small enough to be hidden by the light but large enough to stuff wirenuts/wire into... I suspect that this would not pass code in most places. I wrapped every wire and wire nut very heavily and had to create a decorative PVC wall block to mount these over just to feel comfortable.

As others mentioned the wires are super thin making it difficult to install. A bad feature is there is no seal to go between the fixture and what’re you mount it to. There is a good rubber seal between the glass and the unit, but if you are using this in a wet our outdoor unit, you’ll need to caulk around it. Another thing I dislike is that although you can change the color temps, you have to manually flip the wall switch on and off to cycle between the color temps. It defaults to bright white, so if you want a warmer color and you have multiple lights on separate wall switches, you have to fool around with each wall switch. The could easily have put a selection switch on the motherboard to change the color, but again, they went cheap to save a few cents

It’s beautiful and delivered by tight package. It works great with extreme conditions!

The top part of the light seems great. Sturdy cage, glass, and bracket. Underneath is thin plastc, poor mounting, and worse wiring.This is intended to be mounted to your wall, not an electrical box. Two wood screws and plastic anchors are provided. I used my 3D printer to make a bracket so I could secure it properly to an electrical box.The wires are very thin. The ground wire was so fine I had trouble getting to to stay under the wire nut. If I wasn't using Wago connectors I would be concerned with the power connections being secure. The wires are very short so the connectors can t be tucked into the box. Both power wires are white. Even if you don't care which is hot its still better to code the wires.The plastic base is very thin and you need to take care not to break it when screwing down.